Brophy D-Ring Tie Down Anchor with Backing Plate Review Video

Depends on the condition of the wood but the backing plate of the Brophy D-Ring Tie Down Anchor w Backing Plate #RR5K that you referenced is designed to distribute the weight so that it does not easily rip through the wood. I attached a picture of…

I typically recommend using the etrailer E-Track Backing Plate w/ Hardware - Galvanized Steel - 6" Long x 6" Wide - Qty 1 #e89RR on each end of your E-Track sections #E19148 and one in the middle for added support. With one backing plate on…

The Brophy D-Ring Tie Down Anchor w Backing Plate - Bolt-On - 1/2" Wide - Recessed - 1,600 lbs #RR5K are rated for 5,000 lbs break strength and will work just fine with your application. The 3/4 inch plywood floor is very strong and with the…

The 3-1/4 inch diameter hole to install the part #RR5K is the correct dimension to use. We actually even had a customer come back and say they did it with a 3 inch hole saw. I attached a link to the install video you mentioned as well.

You can attach the Brophy Recessed Trailer D-Ring Tie Down with Backing Plate, #RR5K, most anywhere on a trailer. The recessed D-Ring is designed to be recessed in a wood surface (floor, wall) and using the steel backing plate will make a stronger…

No, it does not matter which wire you use for the ground and which is used for power when wiring electric brakes. Each can be used for either purpose.

We do not, we only carry the #RA20BALL for the rackem tow dolly. Realistically this is the only size you would need. If you were in a situation where you needed the coupler to be latched on to the ball of the dolly you would be in bigger trouble than…

The etrailer E-Track Backing Plates with Hardware part #e76YR work with any of the etrailer Horizontal E-Tracks like part #e42VR. The track and backing plates allow for up to 2,000 lbs but you'll also be limited by the material you're…

Since the slot dimensions and capacity of different brands of E-Track are identical, really the only differences are the finish and the lengths the tracks are sold in. If you're using the E-Track in an area where aesthetics are important, you can…

The Brophy Recessed Trailer D-Ring Tie Down with Backing Plate #RR5K is not application-specific so its preferred method of installation will vary from trailer to trailer. The main factor is the thickness of the material to which it will be mounted.…

E-tracks are typically the stronger of the two, but X-track is more versatile since you can mount them horizontally or vertically. Choosing between the two really depends upon how you plan to use them. If you are installing something in a truck bed,…

The Replacement Footplate for etrailer and Ram 2-1/4" Jacks - 6-1/4" x 4-1/2" - 2,000 lbs #JF-100-ZBK is the correct fit for your 2000 lb RAM jack. It will be the exact fit you are seeking.