Optronics Trailer Lights - Clearance Lights - MCL84RB Review Video

It's kind of hard to tell exactly what lights will work for your 1996 Tiffin Allegro, but I think something like the 2-1/2" x 1-3/16" Thinline LED Clearance and Side Marker Light #AL91AB should do the trick. If your lights have…

On the Wishbone 4-Way Trailer Wiring Harness #A35W42B each wire is 20 gauge. It doesn't seem like much but it is more than enough for basic trailer light functions (stop, tail, turn, and running lights). I have linked a video featuring this…

If you are not wanting to use a Adapter 7-Pole to 6-Pole #47549 and would rather wire in a new Hopkins 7-Way RV Style Connector #HM20087 the wiring may be confusing. There may be some trial and error involved as the wiring could have been connected…

There a few things that you can do to figure out what the correct electric brake assembly you will need for your application. First, will be to figure out your axle weight capacity. This can sometimes be found on axles themselves or you can measure…

The LED Trailer Mini Clearance and Side Marker Light with Grommet #MCL10AKB you were looking to install is designed to fit a 3/4" hole. When drilling this hole just be careful that there is nothing behind the area you are drilling. Once drilled…

To connect back up lights you need to have a 7-way trailer connector on both your trailer and tow vehicle. On a 7-way the reverse lights are powered by the center pin. To connect reverse lights to the trailer's 7-way you can use 16 gauge wire…

I attached a help article that details all of the various taillight requirements for trailers based on their dimensions. A good kit to start with would be the part #TL16RK, for an ID bar part #MCL84RB and then for red ID lights for the rear part of…

I do have a solution for you, but the Aluminum Car Hauler Ramp Set #288-07503 that you referenced has a max height of 16" for loading equipment. I did speak with my contact at Gen-Y Hitch who said that their aluminum loading ramps don't have…

I can certainly help you with that. Since the Curt T-Connector Vehicle Wiring Harness, part #C55384 is a 4-way connector the four functions will be Yellow for the left turn and brake, Green is for right turn and brake, Brown is for running lights,…

Since your trailer is over 80 inches wide, you do need the three-light ID bar, which is the following part number: - LED Identification Light Bar for Trailers over 80" Wide #MCL93RB

I took a look in the online version of the owner's manual for your 2011 Ford F-450 Super Duty and it looks like the right turn/stop is fuse location 13 while the left turn/stop is fuse location 14 in your passenger compartment fuse box. In the…

The lights will need to be replaced, we have some great options for this. The Optronics LED Combination Trailer Tail Lights part #TLL160RK looks to be a great match for your existing taillights and the Custer Trailer LED Clearance Identification…