Customers compare MCL93RB to these similar products
Products Featured in this Video
Here we have Optronics sealed 3 light truck and trailer identification LED light bar, part number MCL93RB. This light uses 3 individual AL 91 RB lights. Inside each light is 3 LEDs for a total of 9 that draw .051 amps at 12.8 volts altogether.… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…
view full answer...Since your dimensions match exactly to the Tandem Axle Teardrop Trailer Fender part #HP54VR this fender would work great despite your wheel size being a 15 inch and this saying it's for a 14 inch. The wheel size info we associate with our fenders…
view full answer...A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…
view full answer...Yes, you can use the Hopkins LED Breakaway Switch, #HM20060, with your existing trailer battery as long as the battery is a 12 volt and can power the trailer brakes at or above DOT specifications. On the switch, the black wire will be connected to…
view full answer...The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…
view full answer...Light truck tires (LT) are sometimes used in RV applications but generally not on utility trailers. Light truck tires are a type of passenger vehicle tire and as such they are not built with as thick of a sidewall as trailer tires. A thicker sidewall…
view full answer...I attached a picture that shows the pin out diagram for the Pollak 5th Wheel / Gooseneck T-Connector with 7-Pole #PK11893-11932 that you referenced.
view full answer...Yes, the 7-Pin Round connector is wired differently than the 7-Way flat RV connector. I will list the typical heavy duty truck wiring connections inside the plug on the trailer side for you. At the index guide for plugging the trailer end in to the…
view full answer...I'm not sure I totally believe that the problem is a lack of voltage. It's possible this is the case, but12 volts should easily power a camera designed for a standard 12 volt system. I would recommend taking the camera up near the vehicle…
view full answer...With the 105826 being discontinued from Wesbar, the closest thing available is the Optonics set up #TLL160RK. This is very similar to what you currently have, and is LED like you're wanting, but it would need to be hardwired as it does not have…
view full answer...Thanks for sending us the pictures! Since you are installing a Bolster-and-swivel-bracket assembly part #CE10001G-4 and need a 4-1/8 inch width by 3-1/2 or 4-inch length U-bolt, we currently don't offer a close match. I would recommend going to a…
view full answer...The lights will need to be replaced, we have some great options for this. The Optronics LED Combination Trailer Tail Lights part #TLL160RK looks to be a great match for your existing taillights and the Custer Trailer LED Clearance Identification…
view full answer...