Master Lock Hitch Pins and Clips - Standard Hitch Pin - ML1465DAT Review Video

There is a trailer coupler designed specifically to be used for offroading, from Lock N Roll. This uses an articulating connection between the coupler and accompanying hitch mount that gives a full 360 degree rotation between the two. So the…

You are definitely on the right track here. When it comes to weight distribution hitches, it all comes down to your tongue weight. All of these systems will have a range of tongue weights that you want to stay within for them to work effectively. I…

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only…

Good question, and the hitch on your Audi is not rated for use with weight distribution, so what I recommend instead is a friction sway control set up. This will provide you with better control over your trailer to give you a much more controlled,…

The #336VS503515 comes with the adjustable channel bracket along with the adjustable channel mount and bolts. You will need to install the channel mount in the appropriate rise/drop position since it does not come fully assembled. It looks like you…

If you're wanting to use the Roadmaster Dual Hitch Receiver Adapter #RM-077-2 for towing a tow dolly then yes, either receiver can be used. If you're talking about towing a trailer then we need to find you a different adapter because these…

Weight Distribution is a good idea whenever the loaded weight of the trailer weighs more that 50 percent of the tow vehicles weight. In addition to eliminating the squat experienced when a trailer is connected, a weight distribution system has other…

Yes, the cam of the Reese Dual Cam III part #RP65FR has been upgraded from models that were made 20 years ago. The brackets have also been upgraded and made to be a lot easier to install as well.

For a weight distribution shank that has 2 more inches of drop than the part #RP54970 you'd want the part #RP63971.

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…

Most trailer hitch balls have a flat part on two sides of the base like the 2" Hitch Ball - 1-1/4" Diameter x 2-5/8" Long Shank - Chrome - 10,000 #A-90 for example. You will simply need a open end wrench large enough to fit that. Vise…

Thanks for reaching out and providing photos! The head of your Reese Weight Distribution System part 113913 is designed to fit a shank with flush sides where the bolts secure like what we see with part part #RP54970, but the Replacement Hitch Ball…