Gen-Y Hitch Hitch Fabrication Parts - Receiver Tube - 325-GH-002 Review Video

To install a trailer brake controller like the Prodigy P2 #90885 or P3 #90195 along with a 7-way socket in your 1994 Ford F-150 the parts you'll need depend on how the truck was equipped from the factory. If it did not come with a factory 7-way…

For your 2 inch tongue the Channel Tongue Trailer Coupler - Trigger Latch - Zinc - 2" Ball - Bolt On - 3,500 lb #CT-3001-Z is my recommendation. Then I'd use the Fulton Fold-Away Coupler Hinge Kit for 2" x 3" Trailer Tongue - Bolt…

According to my calculations the distance from the center of the pin hole to the far end of the shank on Curt combo bar #E-9 is 3-1/2 inches. The bar is 6 inches long overall so from the center to the face of the receiver is 2-1/2 inches.

I went to our warehouse to pull the Curt combo bar #E-9 to provide some measurements. And yes, the Curt combo bar #E-9 will have an internal dimension of 2-inches x 2-inches and outer dimension of the shank is 2-1/2 inches x 2-1/2 inches. The forged…

The outside diameter of the Gen-Y Weld-On Receiver Tube #325-GH-002 is 2-9/16 inch by 2-9/16 inch behind the collar.

For welding on the Curt Solid Steel 2" Hitch Bar, part #D30 a general purpose rod like a 7018 is recommended. If you click the provided link, you can see a product description video.

Yes, I spoke with my contact at Curt and she informed me that every Curt Solid Steel 2 inch Hitch Bar, #D30, comes pre-drilled with a hitch pin hole. Each one of the #D30 is 12 inches long and would come with the pre-drilled hole.

Thanks for sending us a picture. Makes a difference! What I recommend is going with the Curt 2 bike bolt-on rack #C18011 because it will mount to any ball mount or step bumper and can hold 2 bikes with a maximum weight of 70 pounds. Unfortunately the…

The round or trunnion bars refers to the end of the spring bars. Round bars are typically designed for lighter applications, are a bit harder to install and are usually priced lower than trunnion bars. Trunnion bars are typically designed to be used…

I attached a picture that I edited that shows the dimensions of the Curt Hitch part #E17 that you referenced. The side bracket measures 4-1/2 inches tall by 5-1/2 inches long, and from the bottom of the bracket to the hitch opening is 2-3/4 inches.

That's an excellent question, and the answer is there isn't a hard-and-fast number that means a weight distribution hitch is required. The best way to assess this is if the sag is noticeable, either visually or when towing. You really want to…