Does the Curt Solid Steel 2 Hitch Bar # D30 Come Pre-Drilled with a Hitch Pin Hole  

The Buyers Products Black Receiver Tube #337RT25848B is a receiver tube and not an extension. It will not be able to slide into each other as the tubing is 2"x2" square tubing the entire 4' length. You would be able to connect these…

The Curt Solid Steel, 2" Hitch Bar with Raw Finish - 8" Long #C49537 has a measurement of 2-1/2 inches from the end of the bar to the center of the hitch pin hole. I've attached a video to further assist.

I went to the warehouse and measured, the wall thickness of the Buyers Products Black Receiver Tube part #337RT25848B is 0.27". This has a maximum gross trailer weight of 20,000 lbs so you will not have any issues using it for your farm…

The Curt Solid Steel 2" Hitch Bar with Raw Finish - 12" Long #D30 (manufacturer part number 49530) has measurements with a digital caliper of 2.0015 inches by 2.0130 inches.

It sounds like you need an adapter that will fit into the 2-inch trailer hitch receiver on your vehicle and also be able to attach your cargo basket that uses a 2-inch shank. If that is the case we do offer solid steel fabrication shank bars that…

For welding on the Curt Solid Steel 2" Hitch Bar, part #D30 a general purpose rod like a 7018 is recommended. If you click the provided link, you can see a product description video.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…