Curt Hitch Fabrication Parts - Receiver Tube - E-9 Review Video

We have not before had another customer inquire about your specific application but we do have hitch fabrication parts that might work for you. Please see the linked page. Based on the substantial material of your lift a weld-on part like the 12-inch…

The Dutton-Lainson Hand Winch w/ Automatic Brake #DL15761 has a nut on the crank handle shaft that prevents it from coming off the winch. As you turn the handle in reverse it will look like the handle is moving away from the main body of the winch as…

I reached out to my contact at Dutton-Lainson and confirmed there is not a way to reduce the minimum operating weight required. Both the #DL15761 and the #DL14964 use the same brake pad and washer. However, #DL15761 (2,500 lbs) is physically…

I went to our warehouse to pull the Curt combo bar #E-9 to provide some measurements. And yes, the Curt combo bar #E-9 will have an internal dimension of 2-inches x 2-inches and outer dimension of the shank is 2-1/2 inches x 2-1/2 inches. The forged…

The outside diameter of the Gen-Y Weld-On Receiver Tube #325-GH-002 is 2-9/16 inch by 2-9/16 inch behind the collar.

According to my calculations the distance from the center of the pin hole to the far end of the shank on Curt combo bar #E-9 is 3-1/2 inches. The bar is 6 inches long overall so from the center to the face of the receiver is 2-1/2 inches.

I have just what you will need. I have linked an FAQ article that explains the various ways to wire a winch. You will need the second half of the page titled Option 2: Wiring the Winch to a Separate, Trailer-Mounted Battery. I have also included a…

You are correct in your description of how to wire in a new auxiliary battery in your enclosed trailer. You will take the 7-Way's 12V power feed and route this to the positive terminal on the auxiliary battery, and you will ground the second…

The Demco HiJacker 5th wheel trailer hitch #DM8550024 is two parts. The main part is the hitch itself and its base. The other part is the side rails and its parts. The side plates will have to be bolted to the base with the included hardware. The…

The flanges on part #E17 are spaced 2-3/8 inches apart and designed to be welded to a bar that fits between them. We also have a couple combo bars that may work better for you. The first is part #E-9. This is a 6 inch combo bar that has a 2 inch…

The plates on the Curt Weld-On 2" Receiver for Custom Fabricated Hitches #E17 are 1/4" thick. The receiver tube is 2-1/2" wide, or 3" if you count the collar at the opening. For a tube size, I would discuss that with the…

You would not be able to mount a winch to a wood bed if you are going to put any kind of load on it. You would need to get the winch mounted to the steel frame somehow. To do this you can use U bolts to attach through the wood bed to the trailer…