Gen-Y Hitch Hitch Fabrication Parts - Receiver Tube - 325-GH-003 Review Video

On the Roadmaster Falcon 2 Tow Bar Cover, part #RM-055-3, the snap clip on the end of the cover will snap into the clip that is located on the inside of the bag at the other end of the opening.

The Curt Combo Bar with 2-Inch Trailer Hitch Receiver #E-11 does not carry a specific tongue weight or towing capacity because these ratings are entirely dependent on the specific installation. The surfaces it is welded to and the manner of…

The Buyers Products D-rings are made in the USA like the part #337B40 which is 5/8 inch diameter like you need and the #337B46 which is 3/4 inch. These are also priced great too so they'd be a very solid choice for you!

Usually loops for the safety chains are on the hitch receiver because a pintle hitch like the Buyer's Products #33710045 you referenecd often connects to a mount the B&W #BWPMHD14003 which slides into a receiver. If this isn't…

Yes, either the top or the bottom hitch opening on the Roadmaster adapter part #RM-077-4 can be used when flat towing a vehicle. I attached a picture that shows it used "upside down."

If I understand correctly the measurement you are asking for, that is highly dependent on how you arrange the bikes and bike rack. If your objective is to identify and ensure clearance of the bike tires to the ground, then I can assure you that if…

The Blue Ox #BX88177 consists of two 1/2 inch diameter and 2 5/8 inch diameter pins. They are only able to have the 4 keyed alike. The measurement is 4-3/8 inches between the opening like #BX88212 which cannot be keyed alike . The only option to…

Trailer tires and wheels do not typically come balanced from the factory like what you see with standard passenger vehicle tires. This isn't usually needed for trailer tires and most car shops don't have the needed setup to properly…

The Gen-Y Weld-On 2" Receiver Tube - 12" Long - Steel #325-GH-003 has a tube thickness of 7/16 inch. The collar thickness is 1/2 inch and the collar length is 3/4 inch not including the weld bead on the back.

I got some information from Yakima and included a diagram of the EXO SwingBase #Y34VR, which is the base part for the EXO SwingBase 2 Tier #Y82VR. Though the measurement from the pin hole to the closest edge of the carrier is not included in said…

I went to our warehouse to pull the Curt combo bar #E-9 to provide some measurements. And yes, the Curt combo bar #E-9 will have an internal dimension of 2-inches x 2-inches and outer dimension of the shank is 2-1/2 inches x 2-1/2 inches. The…

The Ark Drop Down Corner RV Stabilizer Jacks - 33" #ARK77FR is the same as their part number: XODDS850BUS.