Can 2016 Mazda 3 Be Used to Carry a 160 lb Minibike

Question

Question:

I saw a previous question regarding using a hitch mounted motorcycle carrier on the Mazda 3 but it was regarding a somewhat heavy motorcycle. My use case would be a 160lb minibike. Could either the 200lb or 300lb tongue weight hitches accommodate this? Thanks!

asked by: Jay

0

Expert Reply:

The EcoHitch Class II hitches for your 2016 Mazda 3, part # 306-X7305 for a hatchback or part # 306-X7303 for a sedan, will technically fit with the Ultra-Fab Dirt Bike Carrier for 2" Hitches # UF48-979033 and the weight of the carrier plus your bike will be under the 300 lb tongue weight rating, but this carrier is also rated for a Class III hitch so it isn't advisable.

Manufacturers of heavier carriers like this limit the use to Class III hitches because they are simply stronger and can better handle the weight.

You can choose to use these parts together but I have to recommend using a small trailer instead as it will be much safer. You'll need one of the hitches mentioned above along with the T-One Wiring # 118405 and an appropriate ball mount. I'm attaching our ball mount help article so you can ensure you get the correct size if you decide to go with the trailer option.

expert reply by: Jon G

0

Answer 1

Though I can confirm the EcoHitch #306-X7303 will absolutely fit a 2016 Mazda 3, we have yet to do an install with said hitch. However, we do have an install we did with a Draw-Tite #24912 on a 2015 Mazda 3. There will be a few subtle differences,…

view full answer...

Answer 2

You are correct, the Curt Trailer Hitch Receiver #C11377 has a maximum gross tongue weight of 200 lbs. Since you are already at 230 lbs this will not work for your needs. In addition to this, you were wanting to use a 1-1/4" to 2" adapter…

view full answer...

Answer 3

According to the owner's manual for your 2018 Mazda 3, "Your Mazda is not designed for towing. Never tow a trailer with your Mazda." However, if you choose to ignore this recommendation then you will want to use the Curt Trailer Hitch…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 7

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...