Rear Hanger for 3" Wide Slipper Springs - 7-11/16" Tall - 1/2" Bolt Hole

Video Transcript for Review of Dexter Axle Trailer Leaf Spring Suspension - Spring Mounting Hardware - 30-66-1

Hello, everybody. This is Jeff at etrailer.com. Today we're gonna take a look at the 7-11/16 tall rear hanger for three inch wide slipper springs. Now this rear hanger will work with your trailer suspension system. That'll have a three inch wide slipper spring, provides attachment points for the leaf spring. The hanger will basically suspend the spring from the trailer frame by providing a resting place for the slipper end of the spring.

This is designed for trailers with a 10,000 pound or 12,000 pound Dexter axle. We mentioned it fits the three inch wide slipper spring. So just to show you the inside measurement. That'll be right at about three and a quarter inches. It is designed to work with a half inch diameter bolt.

Right here is where the bolt will go through and the diameter of that hole is half an inch. And when we say 7-11/16 inches tall, when you measure the height of a hanger it's measured center of that bolt hole to the top of the hanger. So if we get our ruler and we go to the center, very top, you can see that meets your 7-11/16 overall height. But that should do it for the review on the 7-11/16 inch tall rear hanger for three inch wide slipper springs..