Summer Starts Here - Save up to 70%
1" ID x 2" OD x 3" Long. Replaces 1 rubber bushing with steel sleeve. Installs in the center bolt hole of your slipper spring for 10,000-lb to 15,000-lb Dexter axles.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're going to take a look at the rubber bushing with the steel sleeve for slipper springs this is a quantity of one. Now this rubber bushing with the steel sleeve on the inside is designed for use with trailer suspension systems. It will replace the rubber only bushing on your slipper spring. The suspension bushing will insert in the center bolt hole of your slipper springs to ensure proper sizing for the suspension bolt. This is designed to fit the slipper spring suspension for 10,000 pound to 15,000 pound Dexter axles. You'll notice it's a rubber bushing and on the inside has the sturdy steel sleeve.
Now a few dimensions on this. We'll start with the overall length from edge to edge you're looking at three inches. Diameter from edge to edge is going to be right at two inches and the inner diameter where the bolt would go on this sleeve is one inch. And again this is for a quantity of one. But that should do it for the review on the rubber bushing with the steel sleeve for slipper spring quantity of one..
Average Customer Rating: 4.8 out of 5 stars (27 Customer Reviews)
1" ID x 2" OD x 3" Long. Replaces 1 rubber bushing with steel sleeve. Installs in the center bolt hole of your slipper spring for 10,000-lb to 15,000-lb Dexter axles.as always, product and service was a 10/10. This order was my 5th or 6th in the last few years and I have never had any problems.
Bushing are fine, perfect fit. Austin was a great help. Thank you so much
I received bushing and the bolt plus a spare set for the 10K axle according to the website and did not get what I expected. The outside diameter of the bushing is correct but the inside should have been three quarters of an inch as well as the bolt. Turns out it was a wasted effort and I will contact my local trailer place to get what I need
I did not use these as intended.... I built sway bars for an agricultural sprayer and used these in the connecting points to lessen the shock load given to the sway bars. Used 2" scdp 40 pipe as a sleeve and it worked wonderfully, pressed in without any trouble.
These rubber bushings are just what was needed for my hendrickson air bag suspension they are strong and seem to be holding up good
i was able to update my trailer and make suspension tight again
Good product
Good product
Will work perfect for my application.
worked as it should
Thank you so much for your patience Shawnee. You were great. The parts were delivered fast as well
GREAT PRODUCT!
as advertised. seems to be good quality.
Arrived on time, perfect fit
Thank you for your service I really appreciate it
Very helpful and prompt service
Do you have a question about this Trailer Suspension Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.