Ultra-Fab Trailers and RV Power Twin II Manual Stabilizer Review Video

I got my hands on the Removable Xtreme Off-Road Swing-Up Trailer Jack #ARK47FR and was able to determine that it can accept a 2" outer diameter tube inside the mounting tube and has a 5/8" diameter retention pin. If you remove the…

We have had confirmation that the 2018 GM factory fifth wheel rail kit is the same as the 2017 so if you had a short bed truck you'd want the slider Companion part #BWRVK3770 or if you had a long bed truck you'd want the part…

I have attached a few photos for you with all the dimensions we have for the Ark Drop Down Corner RV Stabilizer Jacks part #AR34FR. That said, Ark is an Australian company so the measurements are in metric, millimeter to be specific so you may need…

For your Lippert Components Power Stabilizer Trailer Jack #LC298707 the wiring is pretty simple. There are two wires that come out of the motor and they are both used as power or ground depending on the direction you want to turn the motor. To…

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

The diameter of the pull pin that holds the #ARK47FR jack in place on the mounting bracket is .5512".

The overall height of the Round, Pipe Mount Swivel Jack #TJP-5001S-B is 16-3/4 inches when fully retracted and 26-3/4 inches when extended. Basically from the center of the pipe mount to the top of the jack measures 6-1/2 inches.

We can get your stabilizer set up, and I can tell you where each of the four wires go for the Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors #UF39-941705. I have added a cut out for you of the installation instructions which cover how…

I contact Ultra-fab and since the socket on the Ultra-Fab Power Twin II Manual Stabilizer for Trailers and RVs part #UF39-941704 is not a standard hex socket head there is not a way to raise and lower the stabilizer with a power drill. The socket on…

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set #LC675817 is only suggested for the 8 inch and larger frames as you referenced. I confirmed this with my tech contact at Lippert. The best option…

The mounting bracket for the Ultra-Fab Power Twin II Manual Stabilizer #UF39-941704 is approximately 35-3/8" in length. The frame height would dictate the amount of lift you would want but there are other factors to take into account. The…

I attached a picture that I got from Lippert that shows the wiring diagram for their stabilizer jacks like the part #LC298707.