Mounting Pipe Diameter For The Ark Removable Xtreme Off-Road Swing-Up Trailer Jack

Question

Question:

Currently have a pipe mounted jack like TJP-5002S-B. Would the ARK47FR fit on the pipe already welded on and be useable without the mounting hardware?

asked by: Steve A

0

Expert Reply:

I got my hands on the Removable Xtreme Off-Road Swing-Up Trailer Jack # ARK47FR and was able to determine that it can accept a 2" outer diameter tube inside the mounting tube and has a 5/8" diameter retention pin. If you remove the current jack and find that the tube bracket welded onto the frame of the trailer is 2" in diameter then you'll be able to mount this jack without using the clamp-on brackets.

expert reply by: Kevin C

0

Pipe Mounted Trailer Jack
(click to enlarge)

Answer 1

Here is an image I have from the Xtreme Off-Road Swing-Up Trailer Jack #ORJW750D in zinc which will have the same dimensions as the black Jack #ORJW750BD you are looking at.

view full answer...

Answer 2

The diameter of the pull pin that holds the #ARK47FR jack in place on the mounting bracket is .5512".

view full answer...

Answer 3

The overall height of the Round, Pipe Mount Swivel Jack #TJP-5001S-B is 16-3/4 inches when fully retracted and 26-3/4 inches when extended. Basically from the center of the pipe mount to the top of the jack measures 6-1/2 inches.

view full answer...

Answer 4

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 5

Hey Sam, thanks for reaching out! The Ark Articulating Off-Road Coupler for 2" Receivers #AR44FR is a great way to add some versatility in where your trailer can be towed, but since everything can move around it does present some challenges when…

view full answer...

Answer 6

We do have potential options for you, but there are no bolt-on options that will be a direct fit for a 6" tall 3" wide frame. One option is to use the ARK Extreme Off-Road Swing-Up Trailer Jack #ORJW750BD. This jack is made to fit frames…

view full answer...

Answer 7

The weld bracket on the top of the Ark Drop Down Corner RV Stabilizer Jack Kit #ARK34FR is 4.6063" long and the surface that would make contact is 1.8307" wide. The overall width is 2.8543" on the top. I have attached a dimensional…

view full answer...

Answer 8

The Ark Drop Down Corner RV Stabilizer Jacks - 33" #ARK77FR is the same as their part number: XODDS850BUS.

view full answer...

Mounting Pipe Diameter For The Ark Removable Xtreme Off-Road Swing-Up Trailer Jack

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching