etrailer Stabilizer Jacks Review Video

Hey Jaime, yes you can replace your 25-1/4 inch 3,500 lb axle leaf springs with a 5k rated axle spring like the part #e44SR. This will increase the suspension's weight capacity and might make the ride quality a little rougher but it would fit…

Hey Kevin thanks for your question. There is not much downside to going with the 5,000 lb springs instead of the 3,500 lb. A higher rated spring may make the ride a bit more "chunky" at times, since the spring would not flex as…

There many possible ways to mount a stabilizer jack such as the #TJ01RT-HD you looked at. Mounting them in the orientation shown the diagram would tend to work a bit better to stabilize the trailer against side to side movement, while having the…

As long as your GearDeck is pre-2021 the Lets Go Aero Flat Pipe Spine w/ 2" Shank for Pre-2021 TwinTube Platform Cargo Carriers #H01373 will fit.

The 4-Leaf Double-Eye Spring #e44SR is our closest leaf spring to the Dexter 072-078-00 which we do not carry. Each of these springs is the same 25-1/4" from eye to eye but are rated for 2,500lbs per spring versus the 2,200lbs you are…

Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…

The K-Source Snap & Zap Custom Towing Mirrors #KS80930 I feel are the best mirrors extensions for your 2024 GMC Sierra 1500. These have all the cut outs for turn signals, puddle lights and cameras you may have on your mirrors. The snap on…

While trailer axles do feature an upward bend like you are describing, there isn't a particular amount/measurement that is standard across the board. This bend in the axle is designed so that it will straighten under a trailer's loaded…

From the picture you sent in it looks like you are correct and you need the Vent Cover for Ventline Old Style Rounded Dome Trailer Roof Vent #BV0554-03 since you have the continuous hinge style.

Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…

I attached an install video for the Furrion Vision S part #FOS43TASF installed on an RV that was not pre-wired for the Furrion system but was able to easily tap into the wiring needed due to clearance lights being very close.

We definitely have a few options available for a 3,500 pound Dexter axle. That being said, you will need to measure your current leaf springs to see which one will fit. This should be done going from the center of one eye to the center of the other…