Recommended Lippert Landing Gear Set for a 2005 Keystone Montana 5th Wheel

Question

Question:

Customer has 2005 keystone Mt want to change to Lippert. I measured the jacks at 291/2 . Do you sell a complete assembly including motor and gear box that will fit thank you

asked by: Robert

0

Expert Reply:

Yes we do! The Lippert Electric Landing Gear Set part # LC333964 will be an exact replacement for the 2005 Keystone Montana 5th Wheel. It comes with the lead/follow legs, gearbox, motor, and anything else you need for installation. The included mounting brackets and cross shaft will not be used as the ones you have on your trailer now will work in its place. This set comes with a 90 day warranty and is made right here in the USA.

Please let me know if you have any further questions.

expert reply by: Conner L

0

Answer 1

The Lippert Landing Gear part #LC333964 will fit your fifth wheel trailer. At worst you would need to find a qualified welder to move the brackets on your trailer so that they will match up with the landing gear set. If the distance from outside to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

Good news! I was able to go out to the warehouse and measure the etrailer landing gear #RVLG-8HDL for you. I found that the distance between the weld stops from the outside to outside is 17-1/2 inches and from the inside to the inside of the weld…

view full answer...

Answer 5

The sure way to pick out replacement landing gear for a trailer that will bolt right up to the current brackets is to measure the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) if it…

view full answer...

Answer 6

To determine the best landing gear option for your 1997 Forest River Sierra you'll need to measure the where your weld-stops sit to see if there is a matching set so that you can swap over without having to cut off the old mounting brackets and…

view full answer...

Answer 7

In order to pick out a direct replacement for the landing gear on your 2001 sunnybrook 31bwfs we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder…

view full answer...

Answer 8

There are a few things that go into making sure you choose the correct replacement landing gear. First you need to be sure that the landing gear is rated properly. If you check out the weight rating on your current landing gear just make sure the…

view full answer...

Answer 9

The division at Atwood that handled the jacks and landing gear was sold off to Lippert so direct replacement parts are not available. But it is likely that the gear box and motor of another brand will still fit. And yes, the gear box and motor do…

view full answer...

Answer 10

I don't have any way of determining if the Replacement Crank Handle for etrailer and Ram 5th Wheel Landing Gear #RVLG-HDL will work with your 2007 Fleetwood Nitrous Hyperlite TT Toy Hauler or not, unfortunately. The Replacement Crank Handle…

view full answer...

Answer 11

You are correct that the Reese Electric 5th Wheel Landing Gear Set - 8,000 lbs #RP500708 should drop right into place where your Lippert Venture landing gear was. These will support 4,000 lbs each, which is definitely enough capacity for your…

view full answer...