Troubleshooting Landing Gear on Fuzion Toy Hauler That Will No Longer Lift Trailer
Question:
2010 Fuzion 383 Toy Hauler Landing gear My landing gear has hard time lifting trailer, and finally stopped, sounds like dead batteries but they are new. Landing gear and motor flop around, is that normal?
asked by: Tom V
Expert Reply:
It sounds like the landing gear on your Fuzion Toy Hauler may have been overextended, which likely caused damage to the internal gears and screw. This "flopping" that you mentioned is essentially the unit trying to extend but since the internal components have been compromised, it is unable to operate properly, which is producing that extensive vibration and shaking on the leg and motor.
Your best option at this point is likely to replace the entire system. I recommend taking a look at the Stromberg Carlson Electric Landing Gear Set # LG-4. This is a really nice system that will provide you with 34-7/8 inches of total lift and a combined weight capacity of 6,500 pounds, which is more than enough for the weight of your toy hauler. To determine if this will fit the brackets already welded to your trailer, you will just want to take a quick measurement between the brackets. The distance between the top and bottom brackets for the legs on this system is 19-1/2 inches.
I have attached an image with this and some additional measurements labeled, along with a short video demonstration that you can check out.
Product Page this Question was Asked From
Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 6,500 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 6001 - 7000 lbs
- Electric Jack
- Landing Gear
- 35 Inch Lift
- Weld-On
- 2 Jacks
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 6,500 lbs
- Shop: Bulldog Tandem Landing Gear Set - Drop Leg - 36" Lift - 8,000 lbs
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 5,500 lbs
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 5,500 lbs
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Shop: Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs
- Search Results: lg~4
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 6,500 lbs
- Video: Stromberg Carlson Electric Landing Gear Set Review
- Q&A: Replacement Landing Gear for 2010 Open Range 5th-Wheel Trailer
- Q&A: How Do You Determine What Landing Gear Is On Your Trailer?
- Shop: Fifth Wheel Hitch
- Q&A: Replacement Landing Gear for 2002 Carriage Cameo F34CK3 5th Wheel Trailer
- Q&A: Landing Gear Recommendation for a 2002 Carriage Cameo Fifth Wheel Model F34CK3
- Q&A: Are Landing Gear Legs for a 5th Wheel Trailer Brand Specific
- Search Results: 5th wheel landing gear
- Video: Stromberg Carlson Trailer Jack LG-179014 Review
- Q&A: How To Determine What Replacement Landing Gear Is Needed For A 2010 Keystone Outback 285FL
- Search Results: 5th wheel jack
- Q&A: Determining The Correct Replacement Landing Gear For A 2005 Thor Tahoe Transport 5th Wheel
- Video: Review of Lippert Trailer Jack - Camper Jacks - LC196308
- Video: Stromberg Carlson Trailer Jack LG-142178 Review
- Video: Review of Lippert Components - Trailer Jack,Camper Jack - LC141893
- Video: Review of etrailer RV Parts and Accessories - Spring-Loaded Pull Pin - RVLG-SPP
- Video: Lippert Electric Landing Gear Set Review
- Search Results: lc142178
- Search Results: landing gear pins
- Search Results: landing gear motor
- Search Results: stromberg carlson
- Shop: Wheel Liners