Lippert RV Entry Door Threshold Replacement Review Video

Generally speaking, the hub face measurements will be around 15" longer than the spring center measurement. That said, this can vary based on multiple different factors such as tire size, offset, etc. The most common options we offer are the…

I contacted the manufacturer regarding the installation of the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR. They were able to provide me with a wiring diagram which I have included here for you.

Yes, the H-Channel for Enclosed Trailer #36281-955 can be used for the side door frame on your enclosed trailer. It is specifically designed for building cabinets and doors on a trailer. There is also the 1/16" Thick Tube Trim for Enclosed…

I do have an option for you but we only offer the H-Channel for Enclosed Trailers part #36281-955 is one size, 93-1/2" long x 2" tall x 1-1/8" deep. That said, we do offer a C-Channel for Enclosed Trailers in 93-1/2" long x…

Although we do not have the instructions for the Replacement Controlled Motion Hinge for RV Entry Door #LC95VR that you mention I was able to get in contact with Lippert, and they were able to send over the instructions. The instructions are as…

I spoke to TRC and they said the inside channel of the H-Channel for Enclosed Trailer part # 36281-955 is 1.027" wide.

The C-Channel for Enclosed Trailer #362213-955 has an opening of 1.027". I have included an image below with all the dimensions for this item.

I just went back to the warehouse and measured the Z-Rail for Enclosed Trailer - 93-1/2" Long x 2" Tall x 1-1/2" Deep item #362417-955. It is 1/16" thick. You can cut it down to the dimensions you requested but we do not offer…

We likely have an option for you to replace your trailer's tack room lock, but there are no specific replacement parts for your trailer, and we don't have a way of looking anything up, so the best we can do is offer you a way to choose your…

I went out to the warehouse to take some measurements of the Lippert Components Snap Trim Screw Cover #LC326192 for you. The overall height is 0.88 inches. On the inside, between the upper and lower lips, it is 0.75 inches. The short lip sticks out…

Actually, the #MA00-325001 shroud you'd already looked at would be the correct replacement for you. If you click the provided link, you can see a product description video featuring the replacement shroud I recommended.

The correct replacement for an Atwood Water Heater GC6AA-9E is the Dometic RV Water Heater part #DMC74FR. This is a 6 gallon water heater that works with both gas and electric just like the one you have so it will be an exact match.