Size Options for H-Channel for Enclosed Trailers

Question

Question:

do you have available trailer exterior door h channel that is 1 1/8 wide. 1 seems to be standard, but i need wider

asked by: Mike Z

0

Expert Reply:

I do have an option for you but we only offer the H-Channel for Enclosed Trailers part # 36281-955 is one size, 93-1/2" long x 2" tall x 1-1/8" deep. That said, we do offer a C-Channel for Enclosed Trailers in 93-1/2" long x 1-1/8" tall x 1" deep, part # 362213-955 (serrated) or part # 362212-955 (smooth).

expert reply by: Conner L

0

Answer 1

Yes, the H-Channel for Enclosed Trailer #36281-955 can be used for the side door frame on your enclosed trailer. It is specifically designed for building cabinets and doors on a trailer. There is also the 1/16" Thick Tube Trim for Enclosed…

view full answer...

Answer 2

The H-Channel for Enclosed Trailer #36281-955 is specifically designed for use with building cabinets and doors on a trailer. It is a sturdy aluminum that will will work well with the door frame as it is rust proof and will not corrode like…

view full answer...

Answer 3

The closest we have to match those measurements is going to be the H-Channel for Enclosed Trailer #36281-955 which has an internal width of 1.027" and a height of 2". We do also have a C-Channel #362213-955 which has an inside measurement…

view full answer...

Answer 4

I spoke to TRC and they said the inside channel of the H-Channel for Enclosed Trailer part # 36281-955 is 1.027" wide.

view full answer...

Answer 5

Is the battery of the breakaway kit charged? Does your tow vehicle have a brake controller installed?

view full answer...

Answer 6

The first thing to do is disconnect the trailer from the Liberty. Then using a circuit tester, like part #PTW2993, test each pin of the 4-Way. Clip the alligator clip of the circuit tester to the exposed post, the ground wire. Check each pin with the…

view full answer...

Answer 7

Based on the picture you provided it does look like your 1985 Hale Horse Trailer uses the AL-KO 4-bolt pattern and would require you to use the Dexter Electric Brake Kit #23-105-106-09. This kit is designed for 6000lb axles and measures 12" x…

view full answer...

Answer 8

According to the Dexter Axle instructions, the bolts that are used to install the E-Z Flex Equalizer for 1-3/4" Double Eye Springs #013-144-03 should be torqued in the range of 30 - 50 ft-lbs (see attached cutout). Attached is an installation…

view full answer...

Answer 9

Sorry Deborah, I am a little confused with your question. The switch included with the Kwikee Electric RV Step Complete Assembly #LC3658373 when switched on should allow the steps to extend the first time the door is opened and keep them extended out…

view full answer...

Answer 10

The channel itself on the C-Channel for Enclosed Trailer #362212-955 is going to be 1" across the gap. I have attached a picture of this measurement.

view full answer...

Answer 11

I spoke to my contact at Redneck and he gave me the dimensions of this T-Handle Locking Stainless Steel Flush Door Latch #L4080. Check out the picture I attached to see all the dimensions. The only one that is not listed on the picture is the depth…

view full answer...