Convert-A-Ball Ball Mount Adapter Review Video

The distance between the mounting holes of the #RTB1 is 2 inches. The diameter is 5/8 inch.

I contacted our representative at Convert-A-Ball and the weight capacity of the ball mount adapter #BA-1 is 10,000 pounds and tongue weight capacity is 2,000 pounds. It bolts right onto your weigh distribution shank such as the Convert-A-Ball…

According to Convert-A-Ball, although they recommend using the #CABPN-2 3/4 inch pins to secure the #BA-1 it is perfectly acceptable to use 3/4 inch Grade 8 bolts instead of the pins. The only downside is that changing the ball height would be more…

That's a very cool bike so I can see why you want to bring it but the issue is that any type of extension is going to reduce your tongue weight capacity by 50 percent which is not something you will be able to do. The only thing you can do to add…

According to the review video we have of the Brophy #RTB1 ball platform those holes used to vertically adjust this piece are 2" apart on center. It kind of sounds like you have a shank for a weight distribution system as the 1-1/4" height…

The part #C45802 shares the same capacities as the ball mount it is designed to fit part #D900. Which is 10k when using the largest ball size of 2-5/16 inch.

I read through the installation instructions for the Air Lift 1000 air Helper Springs, #AL60774, and in section C of the instructions there is a step that stats that you may have to drill a 3/4 hole into the lower spring seat on certain vehicles. The…

According to the instruction for the Air Lift 1000 Air Helper Springs #AL60774 on your 2017 Nissan Murano, there is no step listed for removing the bump stop. This air bag works differently in that it is not providing vertical support like most…

I took a look at the Ram's owners manual and it states if the trailer weighs more than 1,000 lbs loaded, it should have its own brakes. Towing the 3500 lb trailer without braking could lead to accelerated brake lining wear, higher brake pedal…

To add a 2-5/16" and 2" hitch ball to a shank like the Curt #C45059 you mentioned you would need the Replacement 2" Receiver for Curt Multi-Ball Adjustable Ball Mount #C45802 and Replacement Tri-Ball for CURT Adjustable Ball Mount…

I have a solution for you, but the Curt #C45059 has a slightly different hole orientation than a typical weight distribution shank. For this reason, you would only be able to use the parts designed to work with this Curt shank-you will need to use…

In regards to the Replacement 2" Receiver for Curt Multi-Ball Adjustable Ball Mount part #C45802 which is a replacement for the Curt Multi-Ball Adjustable Ball Mount for 2" Trailer Hitches part #D900, the two holes are spaced 2-1/2"…