Rebuilding etrailer and Ram Sidewind Jacks Video

For the replacement cap that will cover the manual override on your Electric A-Frame Jack #EJ-3520-BBX, you will just need the Replacement Cap #EJ-3520-BCP. This will include one cap for your jack.

To charge your batteries on your 2015 Lance 1575 from your vehicle or solar power and that is compatible with lithium batteries, I recommend the The Manager30 Battery Management System with Lithium Profile Item #RED88FR and the Pollak…

I spoke to my contact at Fulton and he informed me that the Fulton Magnum series jacks were an older line of jacks that had capacities of over 1,000 lbs. Without knowing what capacity your jack is or what model it is it would be hard to pick out the…

According to Furrion, you'll need the #FR84FR replacement Glass Turntable Plate for your #FMCM15SS microwave oven.

The Furrion LIT Portable Speaker #FBS012NVPPS is designed to charge off a micro-usb Cable #332-HDEZ4 when charged inside your home. You will be able to use this type of cable with a cell phone style charger when in your house. If you prefer the Dock…

Yes, the replacement glass plate part #FR84FR does fit the Furrion Microwave FMCM15-BL that you mentioned.

Yes, you can use 10 Gauge Wire #10-1-1 to route through your axles to power your Electric Brakes #K23-478-00 Do be sure the Grommet #046-124-00 is in place on your axle tube to prevent the wire from fraying entering the axle tube.

In regards to the Lippert Ground Control 3.0 Leveling System (what you were looking at), there are no replacement inner tubes available. Therefore, if you bent the inner tube on the front leg then you will need to replace the entire leg for which we…

The distance between the insides of the weld stops on the jack leg #LC362485 is 17-1/2 inches and the outer tube diameter is 2-1/2 inch by 2-1/2 inch.

Good news! I was able to go out to the warehouse and measure the etrailer landing gear #RVLG-8HDL for you. I found that the distance between the weld stops from the outside to outside is 17-1/2 inches and from the inside to the inside of the weld…

Depending on how the trailer was made, there will be a few spots you can check to identify the axle. First, if the trailer was pre-made by a specific company, you may be able to find this information in either the paperwork or on a placard somewhere…

When it comes to 5th wheel landing gear like #RVLG-8000, tongue jacks or winches, it is usually best in the long run to use an over-spec product that can handle more weight than you're going to ask it to. This tends to increase the working…