Redline Dust Cap Driver Tool Review Video

Pete, yes the Snap-In Plug for Lionshead Trailer Wheel Center Cap #LHSI60C are definitely not brittle and are better made than most. This is still made of plastic, has a chrome finish, and will work with 15" to 16" diameter wheels with a 6…

The correct grease cap for the Dexter Trailer Hub and Drum Assembly for 8,000-lb E-Z Lube Axles #DX46XR is the #TRU66FR.

For the TruRyde Lubed Dust Cap and Rubber Plug #DC250L-DCRP referenced in your question, which has dimensions of 2.45 inch x 1.52 inch x 1.18 inch, you can use the Redline Dust Cap Driver Tool - Medium #290-992. This can be used for installation,…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

Yes, you can replace your load range C tires with load range D tires without issue. It will only become any issue when you go down load ranges, not up. The tires will have the same overall diameter as long as they are the same size regardless of…

If you remove the hub and wipe away the grease on the spindle you can check to see if it is damaged. Look for an scarring, gouges, discoloration, or scoring on the spindle. If the spindle is damaged then the bearings won't ride properly and can…

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

Though there can be some variations, the #GS-2250DL (10-36) seal would lead me to believe you have a 5,200 pound or 6,000 pound axle. Especially with a 6 on 5 1/2 bolt pattern on the hub. It would not hurt to pull one of said hubs off to verify your…

EZ Lube Dust Caps, like #DC200L-DCRP, have a rubber plug that can be removed to access the zerk fitting. The rubber plug can be removed by gently prying it up with a flathead screwdriver. If your dust cap is in good condition and you want to avoid…

I do have an option for you but the Pop & Lock Custom Tailgate Lock part #PAL8340-PL9510 is designed to work with the factory tailgate handle so there would be no way for me to confirm it will work with the Master Tailgaters Handle you are…