Dexter Trailer Hub and Drum Assembly Installation 42866UC3-EZ Video

It does! I checked with Lippert for you and the exact replacement that matches up with your 814202 hub is the part number you listed: - Easy Grease Trailer Hub and Drum Assembly for 6K Axles #AKHD-655-6-G-EZ-K

Dexter hub drum assembly #8-219-13UC3 is a replacement for your hub drum according to my contact at Redneck Trailer Supply. This is rated for 7K, has a 8-on-6-1/2 bolt pattern and 9/16-inch studs. You can also identify compatible replacement…

We don't have that exact part number but for basically the exact same hub except made by Dexter you'd want the part #8-219-13UC3. This is the sam 6k-7.2k hub with an 8 on 6-1/2 inch bolt pattern that uses 9/16 inch studs just like the one you…

The Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 8 on 6-1/2 - 9/16" Studs #8-219-13UC3 will fit on your Lippert axle. They use the same size bearings and seal.

In order to select a correct replacement hub for the damaged unit on your Jayco 5th Wheel trailer you will need to match several identifiers from the original. First, you will want to note the axle capacity, which is usually found on a sticker or…

The MORryde CRE3000 part #MR27ZR that you referenced was designed for 35 inch wheelbases like you have so it's for sure going to work. Since you have the 3-1/8 inch shackle length currently the correct shackle kit you'd need is the part…

In order to get the correct replacement seal you will want to remove the seal from your hub and get the number stamped on it. If you can't find the number you can also use the dimensions of your seal to get the correct replacement. Get the outer…

It does sound like your bearings are a #L44649 (1.063" inner diameter). If they are original to the trailer they may be pretty worn, which is why your measurements may be off by a few hundredths. Also the seal #34823 that can be used with the…

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

The center pilot hole of electric brake #AKEBRK-6R is 3-3/16 inches. The mounting pattern does have the holes spaced 2-1/8 inches apart on center except from the bottom 2 which are spaced 3 inches apart on center. I have included pictures of these…

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

The Lippert Center Point by Trailair Air-Ride Suspension Upgrade part #LC1565401 is compatible with nearly every trailer on the market. That said, if you want to do a bit of research to ensure a smooth installation that would be best. For starters,…