etrailer Trailer Hub and Drum Assembly Installation akhd-865-7-2-ez-k Video

The Dexter axles you have are 7k rated based on the part number you mentioned so the etrailer leaf springs part #e64SR that you referenced would be the correct part number as long as your current springs are right at 25 inches unloaded. If you have…

There is no specific torque rating when reinstalling the castle nut after packing the bearings. You want to run the nut down until there is no side to side play in the hub, and then back it off to the next notch in the castle nut so the retainer…

The 6-Leaf Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR is manufactured in China.

It does! I checked with Lippert for you and the exact replacement that matches up with your 814202 hub is the part number you listed: - Easy Grease Trailer Hub and Drum Assembly for 6K Axles #AKHD-655-6-G-EZ-K

In order to remove the hub/drum on your trailer you will want to first remove the spindle nut. Once the spindle nut is removed you are going to want to take a hammer and tap the outer portion of the drum as well as the hub face a few times to break…

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

We don't have that exact part number but for basically the exact same hub except made by Dexter you'd want the part #8-219-13UC3. This is the sam 6k-7.2k hub with an 8 on 6-1/2 inch bolt pattern that uses 9/16 inch studs just like the…

In order to select a correct replacement hub for the damaged unit on your Jayco 5th Wheel trailer you will need to match several identifiers from the original. First, you will want to note the axle capacity, which is usually found on a sticker or…

Dexter hub drum assembly #8-219-13UC3 is a replacement for your hub drum according to my contact at Redneck Trailer Supply. This is rated for 7K, has a 8-on-6-1/2 bolt pattern and 9/16-inch studs. You can also identify compatible replacement…

The Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 8 on 6-1/2 - 9/16" Studs #8-219-13UC3 will fit on your Lippert axle. They use the same size bearings and seal.

There are a couple things that you will want to verify first, but more than likely you will be able to switch from your current 16" wheels to 17.5" wheels like the Aluminum Lynx Trailer Wheel #274-000006 you were looking at. The…

Standard tapered trailer wheel bearings are recommended to be re-packed with fresh bearing grease about every year or every 12,000 miles under normal use. In certain conditions this interval could be shorter, such as if you routinely tow the…