Review of Dexter Trailer Hubs and Drums - Hub with Integrated Drum - 42866UC3-EZ Video

Based on the GVWR of your 2019 Jayco North Point 315RLTS it does seem like you have 7k axles. I recommend verifying this information to be sure. These axles typically use the #14125A outer and #25580 inner bearing found in the Timken #TMK92VR.…

It does! I checked with Lippert for you and the exact replacement that matches up with your 814202 hub is the part number you listed: - Easy Grease Trailer Hub and Drum Assembly for 6K Axles #AKHD-655-6-G-EZ-K

I attached a picture that shows the dimension you are looking for on the trailer hub #AKHD-655-6-K. You'll note there are two different size caps that come with the hub.

Because the face of the magnet rides against the armature (inside) surface of the brake drum, any grooves that had previously been worn into the armature surface will cause the magnet to wear unevenly. For optimal braking performance, you want…

The torque setting for the Kodiak Trailer Wheel Lug Nut, Item #KALN1375S, ranges from 90- to 100-ft-lbs. You will want to avoid using an impact wrench or similar tool because you can not measure the force being applied. For best results, use a torque…

For your Dexter 10x1-1/2 inch brakes the old magnet style was a round magnet, #BP01-068.

Going to a "more powerful" magnet will not give you additional stopping power. All it will do is make your trailer brakes harder to fine tune as they will want to lock up easier. Your best option would be to stick with the proper rated…

The correct replacement magnets for the Dexter assemblies you have is the part #BP01-110 that you referenced as I was able to determine that with the capacity info you gave.

As long as your 5000lb axle uses 12" x 2" brakes like a typical 5200-7000lb axle then the stronger 7000lb brake assemblies will fit just fine. They will provide stronger braking, but that is not necessarily better. If you can adjust your…

Thanks for all of the info on the axle you have on your trailer. Since you have a Dexter 5,200 lb axle with a 6 lug bolt pattern the correct hub/drum you need is the Dexter #K08-201-98.

In order to select a correct replacement hub for the damaged unit on your Jayco 5th Wheel trailer you will need to match several identifiers from the original. First, you will want to note the axle capacity, which is usually found on a sticker or…

The Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 8 on 6-1/2 - 9/16" Studs #8-219-13UC3 will fit on your Lippert axle. They use the same size bearings and seal.