Trailer Brake Controller Installation - 1994 Chevrolet C/K Series Pickup Video

It sounds like the left side may have a bad ground in the system or a loose ground. I would check over the complete wiring system and make sure all grounds have a good metal contact and no rust. Also check the wires to make sure the protective…

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

Brake magnet wires like what are on the brake assembly #23-106 that you referenced can be wired up with either wire getting the positive and the other getting the ground. As long as current runs through them it doesn't matter which wire gets the…

For the etrailer D-Ring Tie Down Anchor #RRING-Q6000 you will need to use the Backing Plate #BP05. This will increase surface area for the bolts used to attach the anchor to your floor giving it additional support. I included a video of the…

The wire gauge of the blue wire on the Hopkins Adapter 4 Pole to 5 Pole Trailer Wiring Adapter, part #47515, will be too small to be able to use as a 12 volt power source. You will need to use a 10 gauge wire on your truck to run a 12 volt power wire…

It sounds like you need to add a 7-Way RV style trailer connector to your 1997 Chevy pickup. Since you already have a connector, you will just need to add a 4 and 7 Way Installation Kit, #ETBC7. Though I am not certain if you have a 5-Way flat…

You will need to hard wire the Tekonsha #TK63VR, on your 1996 Chevrolet CK Pickup. Hard wiring is straight forward and fairly easy to do. We have instructions and a video that I have linked below for you. From the Brake controller here are your…

The Curt Slim Adjustable 2-Ball Channel Mount #C46KR that you referenced has two hitch pin holes that are one inch apart so the first pin hole has a distance of 10 inches from the ball center to the hitch pin and the other is 11 inches.

The 2000 Chevy C/K Series does not have a plug in the relay box or under the dash to plug a brake controller adapter into. To wire in a brake controller like part #90195 it would be a hardwired application. To accomplish wiring in the brake…

There are actually two ways that 7-way wiring colors are commonly seen. One uses a red wire and the other a purple. The circuits they represent do vary though. So check out the updated diagram I attached to this page and most likely you need to wire…

To wire a 7-Way trailer connector at the rear of your 1994 Chevy pickup, you will need to start with a working 4-way connector, item #118315, if your truck is not already equipped with one. You would then use the 4 Pole to 7 Pole and 4 Pole Adapter,…