Trailer Brake Controller Installation - 2008 Kia Sedona Video

What I recommend is a trailer that has a gross trailer weight that meets or is under the towing capacity of your 2015 Kia Sedona which is 3,500 pounds as long as the trailer has brakes. You can tow a trailer rated higher provided that the actual…

If you're not planning on loading the trailer until you get to a destination, you can either leave the trunion bars of your Fastway e2 #FA92-00-0600 completely off the system or loosen the bars up so that there isn't much tension. Either way…

When picking out a weight distribution system the key is to go with a system that has a tongue weight range where your loaded tongue weight falls right into the middle of. You should note that any weight behind the rear axle of your tow vehicle from…

Yes, the dimension you mentioned is the distance from the center of the ball hole on the coupler back on the frame rails 27-30 inches for the Fastway e2 part #FA92-00-0600.

In regards to the Fastway e2 Weight Distribution System part #FA92-00-0600, the only part of the system that will need to be removed when you are not towing are the spring bars. There is an L-pin that holds each spring bar in place. Once this is…

There is a weight distribution hitch option for your new 2021 Intech Flyer Discover with a completely covered A-frame. Instead of using a standard weight distribution hitch which has brackets that go around the frame you will need to use a weight…

I do recommend you use a weight distribution system on the Intech Explore Travel Trailer while towing with your 2018 Toyota Highlander. The reason for this is because the weight of the trailer will be over half the weight of the vehicle which is the…

1. Normally I'd say that your 2016 Kia Sedona would be just fine as long as the pop up has brakes, but since your towing capacity without brakes is only 1,000 lbs it would be a good idea to install one. As far as the warranty is concerned you are…

In order to install the Timbren rear suspension enhancement system #TDVR05096, the first thing you will need to do is lower the rear control arm. In order to lower the rear control arm to remove the coil spring, remove the inner control arm bolt by…

What year is your Kia Sedona?

The black power wire on the #C56407 is just for the powered converter as not all vehicles can handle the additional amperage draw of trailer taillights. This line will not provide the needed power for a battery or other accessory on your trailer, so…

The #C57672 will allow you to convert an existing 4 pin connector on a vehicle and allow it tow a trailer that has a 7-way. By attaching the mounting bracket to the underside of the bumper or chassis of the tow vehicle, plugging the 4 pin on the…