Spectro Snap Bushing Grommet Review Video

The DA91 Demco surge brake actuator that you are looking for is part #DM8750311. This has a 2-5/16" coupler, comes with an electric lockout, is designed for disc brakes, and has a weight capacity of 8,000 lbs towing and 800 lbs tongue…

In order to replace your boat trailer surge coupler you will need to match a number of your trailer's characteristics. You need to select a coupler for the type of hydraulic brakes you have, either disc or drum. Couplers for each type vary…

Brake calipers are typically installed so they point toward the back of the trailer, but it is okay to install them pointing up or toward the front of the trailer. The important thing to consider when installing the calipers is to make sure at…

Yes, the Hydrastar Vented Electric Over Hydraulic Actuator, #HS381-8067, will work with the factory brake controller on your 2011 Ford F-350. The earlier Ford brake controllers had trouble with these types of system, but Ford changed the brake…

There is a good way to get the check valve out of your current actuator and save some money. What you will need to do is remove the large snap ring from the front of your actuator where the brake line attaches, pull the spring out, and at the end of…

You are indeed right to think this way. When picking out the appropriate leaf springs for your custom built trailer you will want to choose them based on what the actual loaded weight of the trailer will be. Just make sure that the leaf springs have…

The 4-Leaf Slipper Spring #e33SR that you referenced actually comes included with the nylon bushing but if a replacement is needed then the 9/16 inch #TRBU11561 that you mentioned would be the correct size and will work perfectly. The correct bolt…

The 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles - 26-1/4inch Long Item #e33SR that you referenced does not require an additional bushing for the hook end to attach to the rear hanger. The hook end of the spring will rest on the…

As they wear, leaf springs tend to flatten out. The first step is to get the correct length of the existing springs. In order to do that, you'll need to put the trailer up on jack stands and measure them (center eye to center of the slipper) with…

I believe you need the 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles #e33SR which measures 26-1/4" from the center of the spring eye to the end of spring.

Have you tried tapping the bolt in with a hammer? Hopefully not much force would be needed. Ideally you get the splines seated all the way but then you don't have to really torque the nuts down as the bolt needs to allow the suspension to move.…

When you bleed the brakes on your trailer after installing the Kodiak Calipers #KDBC225DAC, you will want to start with the brake that is furthest away from the actuator. Of the two bleeder valves, you will want to use the bleeder valve that is on…