Reese Cargo Carrier Test Course Video

The dimension you are looking for is 4-3/4 inches.

The nub you mentioned is actually there intentionally to prevent what you are trying to do as annoying as that sounds. You see there are Class I and Class II hitches that are 1-1/4 inch sized like what you have. The difference is Class II has…

I was able to get an updated version of the installation instructions of the Curt Trailer hitch part #C11402 for the 2016 Hyundai Sonata with under body panel. The the 2-3/4" X 5-1/2" square is cut out between the tabs on the panel…

When we installed the Curt hitch #C11402 on a similar 2018 Hyundai Sonata to your 2019 model we found that from the top of the hitch down to the ground measured 10-1/2 inches. Since Class 3 hitches are only available for higher capacity vehicles…

The Draw-Tite #24965 and Curt #C11402 are a lot alike. They both install on your 2018 Hyundai Sonata in basically the same fashion and have the same weight capacities. They do look a little different because the Draw-Tite has a square cross tube and…

We have the adapter part #HTAD which fits into a 1-1/4 inch hitch and provides a 2 inch hitch opening. You should note that this adapter cuts the capacity of the hitch it is installed in by 50 percent.

We carry one 2 inch trailer hitch receiver to fit your 2015 Subaru Impreza, the EcoHitch, part #306-X7211. However, it only fits if your vehicle has the knock out panel on the rear bumper. If your Impreza doesn't have a knock out panel then…

Yes, you would want to use an anti-rattle for the 1-1/4 inch portion of the adapter. For that the Hitch part #C11257 would work well. It uses a U-bolt to hold the adapter tight to the hitch tube.

The Solera Awnbrella Support Kit for 8' Projection RV Awning part #LC362237 will prevent the canopy from sagging or flapping in the wind but it's still advisable to retract the awning during heavy winds. If you can still see the canopy…

The thickness of the T-bolt head of the part #Y8880184 you referenced is 5/32 of an inch. I attached a picture that has all of the other dimensions as well. These T-bolts are M10 x 1.5 x 25

The Thule replacement M8 T-bolt #853-5715 T-bolt head measures 3/4 inches. The threaded part of the t-bole is 1-inch long, and it has a .30 inch diameter. I have attached a photo of the 853-5715 with the dimensions noted you can check out.

The tallest trailer tongue box that I'm seeing is going to be the DeeZee Specialty Series Trailer Tongue Tool Box - A-Frame - Aluminum - 7.24 Cu Ft - Silver #DZ91717, which is exactly 22-3/4" tall inside; with that said, it's not…