etrailer Trailer Hubs and Drums - Hub - AKIHUB-545-35-G-K Review Video

We do have some options for replacing the Knott calipers and rotors on your Coyote Boat Trailer. We really do not have any info or specs on the Knott brand brakes, but since it is all for a 3,500 lb axle the sizing should be standard. Standard…

After speaking with EZ Loader what you have on your trailer is a 3,700 lb axle. From what they said the axle was upgraded even though your overall trailer capacity is 3,100 lbs. Although this uses the same #L44649 outer and #L68149 inner bearings,…

In order to swap your surge brakes to electric over hydraulic, you're going to need to change out your actuator and add a proper brake controller. For an actuator I'd recommend going with the Hydrastar Electric Over Hydraulic Actuator for…

The Dexter Zinc-Plated Brake Actuator #T47457007K does not have an access hole to insert a screwdriver to bleed the master cylinder. You will have to use the old method with a 2x4 and the safety chains. While the trailer is disconnected from the…

What a lockout on a hydraulic brake coupler does is prevent the brakes from applying when you back the trailer. An electric lock out is tied into the reverse lamp circuit on the vehicle so that when the vehicle is shifted into reverse the solenoid in…

Thank you for all of the photos and information! From what I can see it looks like you have a #84 spindle but that inner bearing blew out so you should be able to remove that inner sleeve that looks like it's still on the spindle (next to where…

The Adapter Port #DE73MR you found is an exact replacement for the one on the Caliper #DE86VR. This is designed to accept a brake line like the Kodiak #bh-3mfs90ff-1-5 and not a banjo type connection. You are going to have to alter your brake lines…

The #DX39FR Replacement Inner Member for Dexter DX7.5L Actuator - Single Axle w/ Disc - 2" Ball is what you need. This is the replacement inner member for Dexter DX7.5L and Legacy UFP Brake Actuators like your UFP A-60 so it would be exactly the…

All of our leaf springs like the 4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles - 25-1/4" Long #e28SR are sold individually. For a single axle you would need two.

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

I don't have any reference material that would tell me which hubs and bearings your 1978 Highlander boat trailer would use. All's not lost, though. If you can supply the proper information, I'd be happy to check the hubs we offer and see…

I looked up the information on your TDE 46205 Hubs and found a couple of great replacements for you. The one you pick will depend on the number of wheel studs you have. For 5 wheel studs use the etrailer Trailer Idler Hub Assembly for 2,000-lb E-Z…