Customers compare TLE1528 to these similar products
Products Featured in this Video
Today we're going to review part #TLE1528. This is the Torque Lift Super Truss Hitch Extension for your Super HitchTrailer Hitch Receivers. This part is 28" long. The review on this is just for the extensionand the support chains on the side. I do have it set up already in a Torque Lift Super Hitch Magnum Receiver for demonstration purposes. This part number would just include the extension part… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
A hitch extender or adapter, like the dual-receiver MT70070, cannot be used with weight distribution (WD) systems. As you note, use of ANY adapter has the unavoidable side-effect of cutting your hitch's capacity by 50-percent. An adapter would…
view full answer...I may have different installation method for you, but there is not an extended bracket made to push the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear #TLA7843 away from your camper to clear your bumper. It may be possible to have a…
view full answer...The hitch opening location for the Torklift Hitch part #TLF1002-30 that you referenced will be very close to where you current hitch opening is. If the 28 extension part #TLE1528 would work well based on your current measurements it would be a great…
view full answer...With a camper on your truck it is difficult to accurately measure your trailer total tongue weight because the cargo weight behind the rear axle is actually spread over the frame and not directly behind the rear axle. So what we do is level with…
view full answer...We are not familiar with the problem you're describing on the TorkLift SuperTruss Hitch Extensions, #TLE1521. TorkLift makes their products here in the USA, but it is possible that your extension was made on a Monday. I spoke with my contact at…
view full answer...In short, yes you can hook batteries from different brands in parallel. You would want to ensure that the batteries are of the same type though. You should not mix different types (deep cycle and starting), chemistry (wet cell /AGM/GEL...) or the…
view full answer...I spoke with my contact at Curt and he had a way for you to release the ball from the underside of the hitch. From underneath of the vehicle the customer will have to remove the cover/plug on the bottom of the ball if there is one. This will reveal…
view full answer...We sure do! For the factory gooseneck hitch on your 2018 Ram 3500 I recommend the Curt Ball and Safety Chain Loops Kit #C60618. This kit includes the 2-5/16 inch hitch ball that will mount to the factory gooseneck receiver and the 2 safety-chain…
view full answer...I contacted Venture Trailers Inc. and found that the reason they do not recommend the use of a weight distribution system is because most weight distribution systems are not recommended for trailers with surge brakes because they do not allow the…
view full answer...The TorkLift SuperHitch Magnum trailer hitch receiver, part #TLC1211-30, has about 3/4 of an inch between the 2 receiver openings. The top receiver is a 2-1/2 inch (with a 2 inch adapter sleeve included) and the bottom is a 2 inch. It's confirmed…
view full answer...Drilling a hole in your hitch receiver will void your manufacturer's warranty if something were ever to go wrong with it. For that reason, I think the best solution to use an anti-rattle hitch pin that won't require any drilling, like the…
view full answer...The bracket of the Aluminum Scissor Steps #AS04 that you referenced stays attached to the camper, but the steps themselves get removed while traveling. Check out the review video I attached for these steps as well.
view full answer...