Customers compare C17322 to these similar products
Products Featured in this Video
Today we're going to be taking a look at part number C17322. This is the Curt Weight Distribution System, and it's going to include a sway control system. This unit's going to help evenly distribute the weight over the axles, of your tow vehicle and your trailer for safety, stability, and control. It's going to create a more level ride for both the tow vehicle and the trailer. Now this piece right… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The K-Source Snap & Zap Custom Towing Mirrors #KS69NQ are the best mirror extensions we have for your 2023 Ford F-150. These mirrors are custom fit and snap onto your mirrors for a snug fit. There is no additional hardware or straps that can…
view full answer...I do have a solution for you, however, we not offer winch mounting plates specifically for Badlands Winches. Most winches use the industry-standard bolt pattern, but you will want to verify fitment with Badlands or drill your own mounting holes if…
view full answer...A hitch extender or adapter, like the dual-receiver MT70070, cannot be used with weight distribution (WD) systems. As you note, use of ANY adapter has the unavoidable side-effect of cutting your hitch's capacity by 50-percent. An adapter would…
view full answer...For your 20 Foot Outback Enclosed Trailer, the Reese Friction Sway Control Kit - Economy #83660 will use friction to minimize the movement by basically sandwiching the moving bar. This will allow for turning to still happen without issue, but will…
view full answer...You'd need to go with a Short Arm Curt weight distribution system like the part #C17330 which has a 600 lb tongue weight max, the #C17331 for if you need an 800 lb max TW rating, or #C17332 for if you need a 1,000 lb tongue weight max system. The…
view full answer...I confirmed with my contact at Curt that the spring bars of the Curt Trunnion Weight Distribution System part #17302 is 30-5/8 inches. You are also correct about the Curt Short-Arm Systems as they have 28-5/8 inch length spring bars. I attached an…
view full answer...The difference between the two systems is basically the attachment point. One is not better than the other except that the trunnion bars are a little easier to install than the round bars that require a clip to hold them into the head. For the round…
view full answer...The spring bars included with the Curt Short-Arm Weight Distribution System with Sway Control part #C17422 are actually 28-3/8" long. This measurement is taken from the end of each bar with the knuckle removed. The distance from the end of the…
view full answer...You can certainly use a weight distribution system on your lifted truck. The key will be to find a weight distribution shank that offers you enough drop to be able to tow your trailer level. Weight distribution systems are available without a shank…
view full answer...The Curt MV Weight Distribution System w/ Friction Sway Control - Round Bar - 10K GTW, 1K TW #C17062 is not available without the shank. For your raised truck, you can interchange companies for the shank head, however the companies may void your…
view full answer...As long as you don't have the SLT model or extendable stock mirrors, I recommend the CIPA Custom Towing Mirrors #CM11400 for your 2018 Ram 2500. These custom, durable towing mirrors will slide right over the factory mirrors on your truck to…
view full answer...The first step in choosing a weight distribution system is to conclusively determine the tongue weight of your camper once it is fully loaded and ready to tow. This includes full water and propane tanks plus any other gear you would typically travel…
view full answer...