TorkLift SuperHitch Original Trailer Hitch Installation - 2015 Ram 3500 Video

The longest extension available that will work with the factory trailer hitch receiver on your 2014 Dodge Ram 3500 is the Trailer Hitch Extender #e48YR. You will need to measure from the center of the hitch pin hole on your trailer hitch receiver to…

My first thoughts on your Voyager WiSight Wireless System, #WVOS541, are, there is an issue getting a strong wireless signal. You've checked power to the monitor but what about the camera and antennae, please verify that too. If you are getting…

I have attached for you below the pairing procedure for the Voyager WiSight Wireless RV Backup Camera System part #ASA84YR. Please note, a mistake I have made in the past was applying power to the camera too soon, this cannot be done until the…

A hitch extender or adapter, like the dual-receiver MT70070, cannot be used with weight distribution (WD) systems. As you note, use of ANY adapter has the unavoidable side-effect of cutting your hitch's capacity by 50-percent. An adapter would…

Yes, the TorkLift SuperHitch Magnum Trailer Hitch Receiver #TLD1109-30 will fit your 2019 RAM 2500 Power Wagon with the 6-1/2' bed. According to the installation instructions no modification of the spare tire location/support is needed. The…

The camper tie-downs that are designed to fit your 2017 Ram 3500 that I recommend are part #TLD2124 for the front and part #TLR3507 for the rear. These are specifically designed for a 2017 3500 Crew Cab With no running boards or steps and with an…

The rear Torklift tie downs you referenced part #TLF3507A are the set for your 2017 Ram 3500 dually once you swap the factory hitch for the Torklift SuperHitch part #TLD1108-30. Torklift also does not offer these parts separately.

For your 2016 Ram 3500 you would need a Magnum Superhitch like part #TLD1108-30 that works in conjunction with the factory hitch. You will then need to change the rear Torklift Hold Downs to part #TLR3507.

The best image I could find of B&W hitch #BWHDRH25211 was in the instructions and it is a line diagram and not an actual picture. But it shows how the new hitch receiver will be directly beneath the factory receiver on your 2012 Ram 2500/3500.

As long as it is properly installed the HappiJac Extender Bracket #HJ54FR won't cause you any issues. Will it add some stress? Of course it will since you're extending the jacks out. However, it won't be enough to result in a problem and…

If you have a pre-existing mounting bracket on your 2020 Palomino truck camper then that means it is pre-wired for a Furrion Vision S camera system. These are wireless and come with 2 different monitor screen sizes: 4.3" - #FOS43TASF or 5"…

The running light fuse for the trailer lights on a 2013 Dodge Ram Pickup is located in the engine bay fuse box in the F29 cavity. It should be a yellow 20 amp fuse. If the fuse is intact then the easiest way to determine if the problem is on the…