Optronics Trailer Lights - Tail Lights - STL89RCB Review Video

I may have an option for you, but unfortunately the numbers and letters you provided from the bar light on the back of your 2004 Dream Coach Horse Trailer did not cross reference to any lights. Instead we will need to determine the correct light…

The Optronics LED lights, #STL79RB, draws 0.342/.022 amps at 12.8 volts. You will need to make sure that adding additional lights will not overload the electrical system on the tow vehicle or the converter (if it uses one). Also, the other lights on…

90-95 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.

We have a couple of options for vertical trailer tail lights that are 16". I have listed them below. These are our only options for 16" long LED tail lights. 16" x 1-5/16" x 11/16" - Optronics ThinLine LED Trailer Tail LIght…

I might have an option for you but without more detail, like a photo, it would just be a guess. That said, the size you mentioned is pretty common more or less for square trailer tail lights like the Optronics Combination Trailer Tail Light part…

The center-to-center measurement of the Replacement Lens for Wesbar 80 Series Tail Light, #2423286 is 3-3/4" across the top and from top to bottom. Please note the attached image.

The closest taillight solution we have to what you are looking for would be the part #STL264RCB which is a stop/turn/tail light that is an LED strip that measures 20-1/2 inches in length.

If the weight on a tire is heavy enough that the tire deforms then the pressure would increase with added weight. Under normal circumstances the pressure in a tire remains the same regardless if there is a load on them or not. Since the volume of the…

My recommended first step for you to take is to determine what tire size you would need. If you check the plate on the trailer frame near the coupler there will the VIN, axle capacities, as well as the trailer tire size and Load Range recommended.…

The width of the Optronics Flexible LED Light Strip #UCL90CB is about 3/8". I have attached a review video where we take this measurement for you to check out. To help remove the 3M adhesive I recommend using some heat like a hair dryer or…

I attached a picture that shows what type of lighting requirements are needed for a trailer over 80 inches in width as well as a link down below that covers this as well.

Yes you can expand the Diamond LED light strip part #DG52681 that you referenced. We have strip connectors for this light with part #DG52675PB as well as expansion strips like the #DG52697 which would add 33 feet.