Customers compare AM30040 to these similar products
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The Kenda 4.80/4.00-8 Bias Trailer Tire with 8" White Wheel - 4 on 4 - Load Range C #AM30040 may be a replacement tire and wheel for the original 9 inch wheel so long as a couple factors are within the proper specs. You'll need to check…
view full answer...If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…
view full answer...The maximum speed rating for trailer tires is 65 MPH. The B rating is the load rating for the tire, which is 590 pounds at 65 PSI. You always want to have the tires of your trailer inflated to the maximum PSI rating at all times. If they are not…
view full answer...Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…
view full answer...Thanks for the info! Based on that you need the Bearing Kit #BK1-100 which is for the common BT8 spindle like what it sounds like you have. This kit comes with 2 of the L44643 bearings, the matching races, a cotter pin, and a double lip grease seal…
view full answer...Depends on the stud diameter, if you install the part #AM30040 on a 1/2 axle stud you would want to use 80 ft lbs of torque. If on a 9/16 inch stud you would want to use about 140 ft lbs of torque.
view full answer...Generally when picking out a winch for a boat trailer the ratio is 2 to 1 meaning you would need a winch with roughly half the capacity as the weight of the boat. With good rollers and a short winching distance the ratio increases to 3 to 1, but with…
view full answer...Yes, the CE Smith Double U-Bolt Bolster and Swivel Bracket Assemblies #CE10192GA-4 will work as replacements, and you're definitely doing the right thing in replacing them due to the corrosion. You will need to use the CE Smith U-Bolts…
view full answer...I am glad that you like the Kenda Tire/Wheel Combo, #AM3H290. All of the trailer tires that we carry are rated for 65 miles per hour and safe for highway travel as long as you stay at or under 65, follow the weight capacity which is 935 pounds at 50…
view full answer...The TruRyde Spindle #TRU94FR that you referenced has a 1-1/4-inch diameter stub. This spindle will fit an axle beam (pipe) with a 1-1/4-inch inner diameter. While you can certainly fabricate your own axle to go on your homemade trailer, assuming you…
view full answer...For a 4.8-8 trailer tire with the most weight carrying capacity, we have #AM10004. This is a tire by itself and it is rated for 760 pounds at 90 psi. It fits 8 x 3-3/4 inch wheels. The highest rated tire and wheel combo in this size with a 4 on 4…
view full answer...According to our resident tire expert, the 215/60-8 is the modern equivalent of the 18.5 x 8.5-8 tire. I have included a link to a tire sizing FAQ for you that compares different tire sizes. If you just need the tire, we have some options. First is…
view full answer...