Erickson Tie Down Straps - Trailer - 77314 Review Video

The etrailer E-Track Roller Idler #e67HR is 3" from the top of the e-track to the bottom of the roller.

If it were my trailer I would fasten the E-Track to the support beams under the trailer, either the side to side one or front to back ones, by going all the way through those support beams. E-Track like #E19148 is zinc-coated steel and since the…

On an 4 foot long section of E-track #EM19147 and 2 screws every 16 inches that is a total of 6 screws in the aluminum frame. This most likely will not get you near the capacity of the E-track. I recommend bolting through the aluminum frame so that…

Since you have an aluminum trailer I suggest using a tie-down that has a backing plate like #RR5K. This will help reinforce the tie-down since aluminum may not hold up. It would be even better if you can install the tie-downs to the frame of the…

That is going to come down the thickness/type of metal underneath the 3/4" plywood floor on your trailer. If the metal is the frame or crossmember and is made of steel then the Snap-Loc E-Track Self-Drilling Metal Screws - Qty 20 #SL99FR would…

You can install the Erickson Horizontal E-Track #E19148 in any manner you like, so for a car hauler that has cars of different widths you can place E-track side-by-side, as you can see one of our customers did in the accompanying photo. This E-track…

We have seen people mount storage boxes on either side of the nose of a V-nose trailer like what you see in the picture I attached. The part #DZ91717P would work well if you have room for it like that. The dimensions of the box are 36" long…

If you had 3 inch brackets it would look like you have a lift kit basically already installed on your trailer. I attached a picture of the #K71-724-02 installed that you can compare to what you have now to see if your setup looks like it would fit…

For the E-Track Trailer Cargo Control to be able to reach it's full capacity, the direction of the pull should be parallel to the direction that the e track is installed. How much the capacity would be lowered by pulling the load perpendicular to…

While snap up brackets like the Replacement Hook Up Brackets for Curt Weight Distribution Systems #C17208 are somewhat interchangeable, I would still recommend using like branded brackets. The Pro Series weight distribution hitches are manufactured…

Since the slot dimensions and capacity of different brands of E-Track are identical, really the only differences are the finish and the lengths the tracks are sold in. If you're using the E-Track in an area where aesthetics are important, you can…

That's a good question and we have had a number of people wanting to do the same thing, but e-track does need to be mounted parallel to your UTV, in the direction of travel. Wheel straps pulling to the side, opposite the direction of travel, can…