Customers compare 319-S7-05 to these similar products
Products Featured in this Video
Speaker 1: Today we're taking a look at the EZ connector magnetic seven way vehicle end trailer connector. The seven way trailer connector installs at the back of the vehicle to power your trailer signal lights. It is compatible with four pin, five pin, and six pin EZ connector adapters. Adapters are sold separately. The unit uses powerful magnets to join with the magnet and an EZ… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The EZ Connector Magnetic 7-Way Trailer Connectors #319-R7-01 are rated for up to 40amps of power on the 10 gauge wiring. These wires are for the charge line and ground wire circuits. The lighting and brake line wires uses smalle 12 and 14 gauge wire…
view full answer...The only difference between the two landing gear sets you referenced is that Landing Gear #RVLG-8HDL comes with a handle and #RVLG-8000 does not. Apart from that they are the exact same landing gear sets, with 20-1/2" of travel, an 8,000 lb…
view full answer...TruRyde spindles, like #TRU57FR are made of automotive quality high strength steel.
view full answer...There are differences in them but we do have what you are looking for and they can in some situations be used together. The Replacement Trailer Hub Bearing you have part #02475 and Replacement Race for 02475 Bearing part #02420 are designed to work…
view full answer...The #99 trailer spindle is typically found on 9,000 lb and 10,000 lb axles. This is not a spindle that we carry at this time, but I did find some of the measurements. I have attached a diagram showing the dimensions of a #99 spindle for you to check…
view full answer...A goose neck hitch ball, or the center of a 5th wheel hitch head for that matter, will be located either right over the rear axle or an inch or so forward of it. You do not want a goose neck hitch ball to be located behind the rear axle since this…
view full answer...The wires on the EZ Connector Magnetic 7-Way Trailer Connector with Watertight Seal - Hardwire - Vehicle End #319-S7-05 you were looking at are a mix of 14 gauge, 12 gauge, and 10 gauge. The red, brown, green, and yellow wires are 14 gauge, the blue…
view full answer...Thank you for all of the information and your photo! It really looks like you've done your research with all of the various solutions you've looked at to try to prevent damaging the connection between your Lance Truck Camper and your 2019…
view full answer...The EZ Connector Magnetic 7-Way Trailer Connectors #319-R7-01 referenced in your question includes a 2 foot long vehicle-end cable length and a 4 foot long trailer-end cable length. There is not a kit available that features a longer trailer end…
view full answer...To see a couple diagrams that show how the 6-way to 7-way adapter part #47435 is wired up check out the pictures I attached. The 6-way of this adapter has the center pin as the 12 volt circuit. That is the usual circuit that gets moved around on…
view full answer...The Timbren Rear Suspension Enhancement System #TDVRRT is not designed to raise the rear of the vehicle. The other systems aren't either, but they do allow you to tow or haul at the same height so you don't have increased sag and even less…
view full answer...The Timbren suspension #TDVRRT you referenced will help with vehicle sag and it won't change the ride height even when your Caravan is empty, In addition, it will improve your suspension, handling and ride quality, but you still shouldn't…
view full answer...