Dexter Nev-R-Adjust Electric Trailer Brake Kit Installation 23-458-459 Video

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

Since wheels will be able to withstand the psi rating of any of the tires that are meant to fit it you will need to look at the valve stem as that is the deciding factor. If your valve stem has the rubber all the way up to the threads, like part…

You have to be careful if you lubricate electric trailer brakes such as #23-468. You cannot get any grease on the pads or on the inside of the drum because that will have a negative impact on brake performance. The magnet arm and the shoes pivot at a…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Any grease on the back of the wheel could be from the grease working its way out from having slightly too much or it could be from a grease cap or grease seal that is not fitting properly. The grease cap and seal should be keeping any excessive…

The Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 8 on 6-1/2 - 9/16" Studs #8-219-13UC3 will fit on your Lippert axle. They use the same size bearings and seal.

If you have grease coming out the rear seal, you have a bad seal or the incorrect size seal size. The EZ lube spindles will allow you to see grease out the front with the rear seal intact if your seals are working properly as you stated. I've…

I would be happy to help you. The 023-216-00 number you found is for a 10" x 2-1/4" left hand drum brake assembly. To replace it you will need the Left Hand: Dexter Electric Trailer Brake Assembly - 10" - 3,500 lbs item #23-26 and…

If by serial number you mean VIN and the trailer manufacturer is still in business then yes, you would likely be able to obtain the bearing numbers from the manufacturer. If none of the above are true, then the only other way to determine which…

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

Thanks for all of the info on the axle you have on your trailer. Since you have a Dexter 5,200 lb axle with a 6 lug bolt pattern the correct hub/drum you need is the Dexter #K08-201-98.

Torque specs for wheel lug nuts vary depending on several factors like stud size, wheel size and wheel material. The linked image provides a listing of commonly recommended torque values. The studs on your hubs #A35RS545E are 1/2-inch diameter and…