Review of Dexter Axle Trailer Leaf Spring Suspension - Spring Mounting Hardware - DX77XR Video

The bushing that goes with the slipper spring #DX73QR is part #DX77XR. The bushing has a 5/8" diameter so it will work perfectly with the hanger kit #HAP-105-00.

There are a few different hanger kits for a trailer with tandem 10,000 lb general-duty Dexter axles, depending on the axle spacing you have. - 38" Axle Spacing: Dexter Tandem-Axle Trailer Hanger Kit for 2-1/2" Slipper Springs…

So I was able to pull up some information on your Dexter Axle and based on the 008-232-05 number you listed it looks like you have a 9k rated axle. So for Dexter 9k brake assemblies you would want the part #23-451 for the right side and part #23-450…

The only leaf spring bushing we offer with a 5/8" I.D. and 1" O.D. is the Rubber Bushing with Steel Sleeve part #DX77XR which measures 2-3/16" long. The bushing can be cut down if needed. I have attached all our leaf spring bushings…

Based on the number you listed the correct hub/drum you need is the part #8-219-9UC3 which is a Dexter hub for 5,200-7,000 lb trailer axles that have an 8 on 6-1/2 inch bolt pattern.

The reference to 4 leaf springs is the quantity of leaf springs the Tandem-Axle Trailer Hanger Kit, part #AP216-H238. Since it is for a tandem set up you would need to use 4 different leaf springs that are designed for axles up to 8,000 lbs…

The Dexter Trailer Hub and Drum Assembly #8-219-4UC3 fits a standard #42 Spindle #TRU57FR. While the Dexter Trailer Hub and Drum Assembly #8-219-4UC3-EZ fits a E-Z Lube #42 Spindle #TRU37FR. You will need to select the appropriate assembly based on…

The pilot hole on a wheel would have to be 4.75 inches or larger for hub and drum assembly #8-219-4UC3. It can be larger because this hub uses lug nuts to secure and center the wheel on the hub (lugcentric). If it just had holes for wheel bolts…

The Center Hanger for TruRyde Equalizer #TRHG291-C is specifically designed to be used with the Equalizer for 2" Wide Slipper Springs #TREQ4541. This is designed to work with trailer axles from 6,000-8,000lbs. The Redline Center Hanger for…

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

A leaf spring like the part #e28SR has a distance of 25-1/4 inches between the spring eyes. I did some checking and the hanger kit you would want is the Single-Axle Trailer Hanger Kit #APS4. And the distance between the spring hanger centers should…

To replace the wet bolts you're looking for you need the Redline Spring-Eye Bolt with Locknut for Slipper Springs #7-181-6-38. This has a 5/8" diameter and measures 4" long so it will be a little longer than what you're needing but…