Review of Demco Adjustable Trailer Coupler - DM13867-52 Video

The only differences between the Demco Trailer Coupler #DM14976-52 and #DM88XR are the colors and the mounting bracket design. The part DM14976-52 is silver and has a straight, or no-drop, design with the bottom of the coupler being towards the top…

The Demco Trailer Coupler #DM12688-95 does install to a channel bracket using bolts like what we find in the Kit #DM6166. If you were looking for a bolt-on channel bracket then the part #DM13867-52 would be what you're looking for which…

The J-style kayak carrier I recommend that will work on square bars for your trailer is the etrailer J-Style Kayak Carrier #e98878. This will mount around your square bars that are up to up to 3-1/8 inches wide and 1-1/2 inches tall. This is a…

For mounting the Demco 5-Position Adjustable Channel Bracket #DM13867-52 you will need to source 1/2" grade 5 mounting bolts from your local hardware store. This will allow you to secure the bracket to a 3" wide channel tongue.

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could…

The Brophy Lunette Ring w/ 5-Position Adjustable Channel Bracket #BR63ZR is most definitely a weld-on installation and you'll use those holes as a reference point during the installation. A lot of times seemingly random holes like these are…

You will be able to slide the Lock N Roll 3-Position Adjustable Channel Bracket #336TS505 into the 2" receiver on the trailer. This will allow you to bolt in the Demco Trailer Coupler #DM14976-52 to attach to a 2" trailer ball.

Channel Tongue Trailer Coupler #CT-3001-Z requires a 2 inch wide tongue but I recommend a boxed tongue and not C-channel so there is more support where it counts. Steel tubing at least 1/8 of an inch of wall thickness will do the trick. The length…

For a channel bracket to go along with the Demco 2-Tang Clevis #DM05593-97 that you referenced you would want the Demco 6-Hole Adjustable Channel Bracket #DM59601. This bracket gets welded on, for the hardware to secure the #DM05593-97 to the…

Ideally a hitched trailer will be level to the ground. We often recommend starting off with the hitch ball being a bit higher - an inch or so - than the top of the coupler on the level trailer since once hitched there will be a degree of squat in…

The only difference between buying the Channel Bracket #336TS505 and the Channel Mount #336VS503 separately is only the fact that they are purchased separately. It's the same thing so grab whichever one saves you the most money. ON the…

Yes, the Lock N Roll Articulating Channel Tongue Trailer Coupler - 3" Channel - Trailer Side #336TS508 will fit. The channel width is 3" so it is designed to accommodate a 3" trailer tongue and can be bolted on or welded on…