Convert-A-Ball Hitch Ball - Trailer Hitch Ball - 105LB Review Video

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

I will be happy to explain the best way to not leave marks on the Curt 2" Hitch Ball #C40034. When I tighten the nut when using the hitch ball I use several layers of duct tape or a towel on the shaft portion of the ball when tightening it. That…

The amount of torque needed for the hitch ball you have installed on your Blue Ox weight distribution will be based on the hitch ball you have. Some require a great deal of torque like the Curt hitch balls like the #C40034 that require 450 ft lbs…

Since the RVIA recommends that the breakaway cable be longer than the safety cables, that is what I recommend you to do. This will give you a chance to slow down and recouple the trailer in the event that it gets unhitched from your tow vehicle, and…

The breakaway cable should be longer than the safety chains according to RVIA Recreational Vehicle Industry Association. This will activate the brakes in the event you lose the trailer connection and the safety chains fail which will bring the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…