Command Electronics Trailer Lights - Tail Lights - 328-003-81LBM1 Review Video

The matching passenger side tail light for the Command #328-003-81LBM1 is part #328-003-81BM1.

The license plate light on the bottom of the LED Trailer Tail Light with License Plate Bracket #328-003-81LBM1 that you referenced is clear incandescent bulb.

You could certainly reverse the position of the lamps by installing the #328-003-81LBM1 lamp on the passenger side and the #328-003-81BM1 lamp on the driver's side. Both lamps wire the same way, the white wire is the ground connection, the red is…

I have a solution for you, but unfortunately our trailer light manufacturers don't make an LED light that measures 8-1/2 by 4-1/2 inches. The best solution I have for you would be do buy the incandescent lights and swap the bulbs out with an LED…

Optronics trailer tail light #STL37RB does not include a license plate bracket. This is a left hand side light and not all trailers have the license plate on the left side (though it is most common on the left) so the addition of a bracket would not…

The Optronics license plate bracket part #LP10SB would work great with the taillights part #CE44VR and on your Coyote Lite trailer. It's made from polymer which allows it to be rust proof and one less thing to worry about.

Since you are keeping your current taillights on your Grand Design 303RLS I recommend the ThinLine LED Trailer Tail Light #STL64RCB over the #STL64RB as they have a clear lens. When you use these during the day there will be a more pronounced…

The LED Trailer Tail Light w/ Reflector #DG52720PB comes as just one tail light so you would need 1 for each side of your trailer.

The ThinLine LED Trailer Tail Light part #STL64RCB when used as an identification light at the top of a trailer over 80" wide will only need to serve one function which is to act as a marker/clearance light. Therefore, there will only be two…

The Electric Trailer Brake Kit - 10" - Left and Right Hand Assemblies - 3,500 lbs part #AKEBRK-35 may be the assemblies you need based off the weight capacity of 3,500 lbs. To be sure you want to make sure your existing assemblies are 10"…

Since your current lamps are surface mounted, you'll have some more flexibility in choosing a lamp. Going with an LED lamp is a great idea, brighter light while using a fraction of the electricity. It's not too often you can have your cake…

Your old trailer lights like #MCL67AB are grounded to the trailer via their mounting hardware. Since your new lamps use 2 wires, you'll connect the red wire to the trailer running lamp circuit and install a ring terminal on the end of the black…