Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
8-5/8" x 3-3/16" Rectangle. RV light serves 4 functions: brake, tail, turn, and license plate light. ONE Series provides bright light using fewer diodes than other LEDs. Surface mount with built-in mounting bracket. 3-Wire pigtail.
Features:
Specs:
California residents: click here
Average Customer Rating: 4.8 out of 5 stars (902 Customer Reviews)
8-5/8" x 3-3/16" Rectangle. RV light serves 4 functions: brake, tail, turn, and license plate light. ONE Series provides bright light using fewer diodes than other LEDs. Surface mount with built-in mounting bracket. 3-Wire pigtail.I ordered both the RVSTLB0060 and the RVSTLB0061. My only disappointment with the RVSTLB0061 was the LED module was not attached to the frame like the RVSTLB0060. Luckily, I had two small sheet metal screws I could use to secure the LED to the frame mount.
My installation was on a 2016 Rockwood A212HW. The OEM lights were the Optronics incandescent version. RVSTLB0060/61 are direct replacements except for the odd (offset) drill pattern used during factory assembly (they did not use all the Optronic predrilled holes). OEM mounting screws were reused but I added a bead of glue to the threads to help secure over time. Note the factory uses a good bit of RTV silicon on the top portion of the light frame to help hold in place and fit the slight curve of the body.
Terrific upgrade in my opinion. The installation was pretty easy for me. The light is slightly smaller than the original and I have the corrugated sheet metal siding I did not experience any led hyper flash with this light. I was slightly concerned about this after seeing videos of people changing to led light bulbs on the tow vehicle. This light was plug and play. 4 stars because the manufacturer did not provide a wiring diagram :( I don’t feel you should guess what wire goes where. The least they could do is tell you what they (the manufacturer) wired for ground. In my case, the white was ground, same as my trailer wiring. However I needed to connect green to black to get my turn signal to work. Your situation may be different. Would I buy it again? At this time, yes. I’m hoping this light outlasts my usage of this travel trailer- which should be for many years.
Great fixture to replace the stock incandescent bulb lights.
They were easy to install and work perfectly. They are a big improvement over the original lights.
broke immediately!
Satisfied with the part and service. Installed it on the right side to install a C.G. plate.
Good quality, and functions as advertised. Brighter than the original incandescent units they replaced, but not quite as bright as I had hoped for. It took more time than expected to install these lights, but I was pretty cautious about leaks and used butyl tape under the units, and silicone around the outside. I previously updated all of the clearance lights to LED with Bargman conversion units from etrailer. Our trailer is now 100% LED.
I purchased these to replace my tail lights on my Rockwood trailer. The units I removed used the regular incandescent bulbs and even though they are only 2 years old they were already acting up. They get corroded in the socket areas even with trying to keep them clean. These fit perfect (exact same fixture) are twice as bright the flash is faster (with the LED fitment) and the obvious choice for replacement/upgrade with very little fuss. These have a separate tag light that is plenty bright to illuminate your license plate area. The pricing was excellent and the shipping was extremely fast. Communications with this company is spot on. If you have a question they get right back to you in short order. They also give great recommendations as well. The tail lights were delivered Friday and I installed them in 20 minutes on Saturday. I have purchased from you guys in the past and will in the future. Thank you...
Replacement for factory OEM - 2018 Rockwood hard side A122: Fits perfectly! It’s basically the same lens and bulbs. And etrailer.com had the best price, too.
Not sure why the factory didn’t use the screw holes in each of the corners (maybe they didn’t have long enough screws?), so I swapped the bulbs and used the original back, since it was easier to align and screw the unit back into place.
Decent brightness and good brightness separation between the tail lights and the brake/signal light
Replaced the halogen ones using same holes and location, easy as cutting the old wire, putting the new one on and some silicon.
Lights were very easy to install. Work perfectly. They are just a little smaller than the old type I replaced. Very satisfied with them. etrailer shipped FAST !
Good replacement on our Grey Wolf toy h auler.
Great replacement for my travel trailer.
The product was reasonably priced and arrived in no time at all! I’d definitely buy parts for my camper from etrailer in the future.
Perfect replacement. Thanks so much for making it easy to find.
Products are working fine. Actually looking to purchase some more within the next month.
Perfect replacement for my 2018 Flagstaff Super V. Quick customer service and a fast delivery.
Great deal, easy changeout.
A much needed upgrade. These lights can be seen day or night.
I would buy again.
works great, great fit
Looks same as original except other one was not LED. Will put on couple days.
Easy install. Super bright LED for increased safety.
Great product great customer service!
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Dana
4/2/2018
Everything is still working great. your still bookmarked in my list of places to check when i need something, havent had any more projects lately.