Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
8-11/16" x 3-3/16" Rectangle. Low-profile RV light serves 4 functions: brake, tail, turn, and license plate light. Built-in license plate bracket. Snap-on lens. Mounts on surface of trailer. 3-Wire pigtail.
Features:
Specs:
California residents: click here
Average Customer Rating: 4.8 out of 5 stars (161 Customer Reviews)
8-11/16" x 3-3/16" Rectangle. Low-profile RV light serves 4 functions: brake, tail, turn, and license plate light. Built-in license plate bracket. Snap-on lens. Mounts on surface of trailer. 3-Wire pigtail.First unit arrived broken and was replaced by etrailer no problems.
Many thanks to everyone at etrailer.
Easy to install. Much brighter than the incandescent bulb. Only draw back is it was smaller than the OEM. Had to put stainless screws with silicone in the upper two holes.
Well built, easy installation. Nice LED upgrade to my trailer
Easy replacement.
Great replacement for older lights. This was an exact match.
so far, working great
Lee
1/12/2024
Still working great!!
The color coding on the wires for the lights was way off white was ground green was tail and black was turn. I am a master level john deere mechanic i had to get my volt meter out and trace the wires off of the light Came with no instructions. Once i figured out that the wires that come off of the light where wrong and rewired it up it worked fine
Katrina B.
4/7/2023
You are correct, we do not send instructions with these lights since the wiring information is on our product page. Sorry for any confusion but it states on the product page that the white wire is for ground, black is for taillights, and green is for stop, turn signals.
Ordered to replace brake lights on my rv. Realized one had broke on way to campground. Used 2 day shipping and they were delivered on time. Quickly installed at campsite and boy are they bright! Looking forward to the trip home. Maybe now other drivers can see my blinkers when I turn them on!
Easy change over from the worthless OEM . I don't have to worry about if I I have taillights anymore .
Perfect replacement for my 2018 Reflection 337RLS. Much brighter than old lights. If you order the passenger side make sure you order the matching base color.
Excellent plug and play LED replacement for the cheap factory rear light.
Great replacement for stock incandescent lights. Easy install.
I replaced all the clearance lights and taillights on our fifth wheel camper with these OE style LED versions. They are much brighter and therefore much safer, especially in the case of the tail/brake/turn lights seen elsewhere at etrailer. They should last a lot longer than the original bulb units. I also like the way they look as compared to the old bulb style. Our camper was only a year old, and I don't understand why they all wouldn't come from the factory with LEDs. I installed them all myself without issue.
Grant N.
1/22/2018
Thank you for your follow up. I am still happy with my purchase,although they are installed on a fifth wheel camper trailer that doesnt getused a lot and usually in the daylight hours, so the lights havent got alot of hours on them. So far, so good. Thanks again.
I put these on my 5th wheel camper to replace the originals incandescent lights that from new never looked as bright as they should have been. So I ordered all new LED lights, and so far, WOW!!!!! They are awesome!!!! etrailer is so easy to work with and their follow up from shopping cart to delivery notifications are top notch!! Thank you!!!!!!!!
Bob S.
10/1/2018
Lights are great!! still very satisfied that I replaced the incandescent factory ones with these LED ones. Thanks again guys at etrailer!
Exact replacement fit for the OEM incandescent tail/brake lights. The LEDs are MUCH brighter than the OEMs (both tail light and the brake/turn signal) and add an updated look to my RV in addition to the improved safety factor.
Douglas
7/27/2019
At one point, I had an intermittent problem with the PS tail-light. Traced it to a bad soldered connection, reflowed the solder and all is well since then. Their installation was a good upgrade to my trailer.
Changed out the factory marker lights to these LED markers on our 2018 Grand Design Reflection 5th wheel. Made a big improvement in increased visibility for both daytime and nighttime driving. The installation went well & I found using a putty knife made for easy removal of the original silicone caulk material. I purchased enough of these new LED's in both the red & yellow to change everything out. After doing the first 1/2 of the project I did a comparison with the new LED markers & the original ones and the advantages were quite obvious! Also swapped out the tail/brake lights to LED's & a big improvement there also, along with the added driving safety.
Very bright customer wish she replaced both instead of one
The taillight I purchased is well made and is an exact replacement for the RV. Upon further review, the old taillight was not defective so now I have a new spare on hand.
The white light that is supposed to illuminate the license plate does not work when the trailer lights are on. But the light does come on flashing when the emergency four way flashers are on. This can’t be right.
I purchased these LED taillights as a direct replacement for the stock incandescent fixtures that our 2019 Aliner Ranger 12 came with. I wanted to upgrade to LED for greater visibility and reliability. These were a win on both counts. The best part was that I didn't have to drill any new holes to mount them as the fixture housings are identical.
Perfect LED replacements for my 2017 Grand Design 315RLTS travel trailer's incandescent lights. These lights fit the existing mounting holes on our camper perfectly and are a huge improvement over the original lights. Another great feature of this light is that it contains a separate set of LEDs for the license plate.
Great service and fast shipping
I had lost the lens on the way home from a music festival. I was having a hard time finding it at my local trail repair places. I found etrailer and ordered one with a white base. It was on back order which would be a long wait they contacted me to see if a black base would work and they could ship it out the next day. What a great way to help a customer. I highly recommend buying everything you can from this company.
Replaced OEM incandescent tail lights in a Signature Ultra Lite trailer. The directionals in original lights were barely visible in daylight. the LED replacements are easily seen in sunlight and are exceptional at night. The upgrade was like for like, same screwholes and even used rubber gasket from originals. All in all very satisfied with product and ease of changeover
I replaced our stock taillights with these LED lights, and after about 10,000 miles and one year, I am happy to say that I am very pleased with them. They are much more visible than the bulb type, which was my primary reason for installing them.
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Gary
7/6/2023
Another year Another cross country trip. Even the US highway system couldnt knock these lights out. If you need replacements Id buy these assemblies. etrailer knows how to run a railroad.