CE Smith Spare Tire Carrier CE27202 Review Video

The Spare Tire Carrier for Trailer with Angle-Iron Railing #e99045 will only fit 12" to 15" wheels so it will not work with your10" wheel. While there isn't another spare tire carrier for an angle-iron railing, there is a good…

Yes. The CE Smith Spare Tire Carrier - Lockable - Steel - 4-Lug and 5-Lug Wheels - 8-3/4" Long #CE27201 will fit your 5 on 5 bolt pattern wheels. There's also a version of this that comes with a padlock included with part #CE27202.

We actually have the exact tire you are looking for. I recommend the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire - Load Range D #AM10130 which will be an exact match for your current tires. If you are also needing a wheel I recommend the…

The two tire sizes you referenced, 4.80-12 and 5.30-12, both fit 4-inch wide rims, but they differ in their overall diameter. A 4.80-12 tire/wheel when fully inflated will have a diameter of 20-1/2-inches while the 5.30-12 size will be just under…

The size 400/480 and 4.00/4.80are the same tire size. The 400/4.00 designation referrers to an older tire size that is no longer available and the 480/4.80 size will replace the older model sized. Therefore, a tire like the Kenda Bias Trailer Tire,…

The CE Smith Spare Tire Carrier - Locking - Steel - 4-Lug and 5-Lug Wheels - 8-3/4" #CE27202 is designed for trailer frames up to 3 inches wide. You will want to have the brackets screw down all the way to the hub or you won't hold the tire…

It is not recommend to jack up a trailer by the axle. This may cause damage to the axle itself. It also puts too much stress on the leaf springs. Instead, you will want to place the jack under part of the trailer frame preferably next to the leaf…

I can end this debate for you real fast! Trailer tires, which will have an ST in front of the size, should always be inflated to the maximum psi indicated on the tire. Trailer tires usually do not have a recommended and maximum psi indication so I am…

We recommend that all trailer tires be inflated to the max psi stated on the sidewall of the tire. If the tire is under inflated, the weight capacity is lowered to an unknown amount for that tire. Although running lower air pressures can improve the…

I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel studs…

In order to verify the spindle dimensions so that you can pick out the correct hub/drum you have to get exact dimensions. For that you need to use a digital caliper like part #PTW80157. For how old your trailer is this is especially important as the…

The PVD or physical vapor deposition that you find on wheels like #460545MBPVD is a tough wear-resistant aluminum coating that is bound to the wheel at a molecular level. It is corrosion resistant until it has been chipped much like chrome plating…