Review of CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE10002G-4 Video

Oddly enough I can't find a decent u-bolt that we carry that would work well for your application.

I have a solution for you but the part #CE10190GA-4 is not available in a half kit so what you would want is the part #CE10190GA with the swivel bracket part #CE10206G. We don't have the bolt and nut though so you would need to supply that…

There are several different tools that could be used. A reciprocating saw is a fairly common tool that most will have access to. An angle grinder with a thin cut-off wheel would also work. If money were no object, a hand-held band saw would be ideal.…

Yes, if you install the #MAL33TR on your Malone Microsport you'd still have the same amount of bar space to carry the same amount of kayaks as you did before. This keeps the bars still above the fenders of the trailer so you don't lose any…

The #CE10002G-4 CE Smith Bolster and Swivel is 13" tall. Assuming you mount it at the position to gain the most height, you should have 9" remaining. Losing the height from attaching to the 3" crossmember leaves you with 10"…

The CE Smith Bolster and Swivel Bracket Assemblies part #CE10000G-4 do not have a specified weight capacity as it can vary by the strength of the u-bolts used in conjunctions with these brackets as well as how many brackets are used per board. I know…

For a u-bolt that will fit a 3" wide x 1-1/2" tall trailer frame you can use the CE Smith U-Bolt part #CE15252A which is 3" long x 3-1/8" wide x 7/16" diameter. Please note, the u-bolt width must be wider than the width of…

I went out to the warehouse and pulled a CE Smith U-Bolt, part #CE15252A and took some measurements for you. The threaded portion is 2-1/16". The outside width is 4". The outside length is 3-1/8". Check out the photo of the U-Bolt…

The Malone MicroSport Trailer #MPG460G uses crossbars like what you would find on the roof of a vehicle instead of bunk boards. This is sold on our site as the Malone Crossbar Conversion Kit #MPG475 and it comes with the mounting hardware. If you are…

The length of the fold away can be shortened in most circumstances. If you have a 3 x 5 inch trailer tongue then the Fulton Fold-Away Coupler Hinge Kit, item #FHDPB350101, can be used and the extension out front can be cut to any length shorter than…

The diameter of the U-bolts that need to be used with the CE Smith Double U-Bolt Bolster and Swivel Bracket Assemblies #CE10190GA-4 is 1/2 an inch. If you do not have enough U-bolts, you can purchase 8 of them with the washers and nuts included with…

We do have coupler hinge kits available but what your 2003 EZ Loader trailer would need depends on the dimensions of your trailer's tongue. The part #FHDPB330301 is for 3 inch by 3 inch tongues, the part #FHDPB350101 is for 3 inch by 5 inch…