Is Half Kit of CE Smith Double U-Bolt Bolster and Swivel Bracket Assemblies Available

Question

Question:

Hi. Is there any way I can purchase half of a ce10190ga-4 ? Thanks.

asked by: Steve Z

0

Expert Reply:

I have a solution for you but the part # CE10190GA-4 is not available in a half kit so what you would want is the part # CE10190GA with the swivel bracket part # CE10206G. We don't have the bolt and nut though so you would need to supply that locally.

expert reply by: Jameson C

0

Answer 1

Oddly enough I can't find a decent u-bolt that we carry that would work well for your application.

view full answer...

Answer 2

The CE Smith Bolster and Swivel Bracket Assemblies part #CE10000G-4 do not have a specified weight capacity as it can vary by the strength of the u-bolts used in conjunctions with these brackets as well as how many brackets are used per board. I…

view full answer...

Answer 3

Based on the picture you submitted it looks like your trailer was originally intended for a different boat and you'd need to made some modifications to it to get all of the bunks to fit the hull proplerly. The CE Smith Double U-Bolt Bolster and…

view full answer...

Answer 4

The diameter of the U-bolts that need to be used with the CE Smith Double U-Bolt Bolster and Swivel Bracket Assemblies #CE10190GA-4 is 1/2 an inch. If you do not have enough U-bolts, you can purchase 8 of them with the washers and nuts included with…

view full answer...

Answer 5

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 8

I have a solution for you but the part #CE10190GA-4 is not available in a half kit so what you would want is the part #CE10190GA with the swivel bracket part #CE10206G. We don't have the bolt and nut though so you would need to supply that…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...