Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The key number you referenced having is associated with an older Diversitech ball mount. I do have an option available for you to consider, however we do not currently carry the replacement key for the R3223 model as it's not available. If…
view full answer...Instead of using the Hydraulic Brake Kit #AKFBBRK-35-D which requires using 14"-16" wheels you should use the Dexter Galphorite Free-Backing Hydraulic Trailer Brake Assembly Right #T4423400 and Left #T4423500. These will fit with…
view full answer...To determine the correct wheel studs you need you're going to have to measure the ones that you currently have. First of all are they drive-in, like #K916WB25 or screw-in studs, like #25-11? You'll then need to measure the length and…
view full answer...The inner bearings should be #LM48548 (1.375 inch inner diameter), outer bearing should be #L44649 (1.06 inch inner diameter) and the grease seal should be #58846. I would recommend you pull your bearings out to verify that but that SHOULD be what…
view full answer...I reviewed all of our trailer wheel bolt inventory and did not have a match for your request. I also contacted our suppliers and was not able to make a match there. The bolts I found were not 13 threads per inch coarse, nor left-handed. I suspect you…
view full answer...Dico was bought out by Titan who now offers 5-on 4-1/2 idler hub #DX22XR. This hub is rated for 2500-lb axles and includes bearings, races, grease seal, grease cap, and lug nuts. You can be assured it will fit the trailer spindle as long as the…
view full answer...The B&W Tow & Stow Adjustable Ball Mounts will either fit a 2 inch receiver, #BWTS20048B, or a 2-1/2 inch receiver opening, like #BWTS20049B. None will fit both a 2 inch and a 2-1/2 inch receiver hitch opening. Normally. Class IV trailer…
view full answer...I checked with Curt and the distance between the vertical mounting flanges of the Curt #C15300 is 33.312 inches.
view full answer...Thanks so much for the photos, and there isn't a replacement for just the front coupler portion of the long-discontinued coupler you have. So in order to switch out from a 2" to a 2-5/16" coupler attachment, you will need to replace the…
view full answer...For your bearings, I recommend the etrailer.com Replacement Trailer Hub Bearing #LM67048. For your seals, I can't find the part number or dimensions anywhere, so if you send me dimensions of inside and outside diameters, I'll do what I can to…
view full answer...The closest modern tire size to a 7.00-15 tire is a 225-75-15 like the #AM10256 tire you mentioned. Typically, a 225/75-15 tire will measure about 8-3/4 to 9 inches wide by around 28-1/2 inches in diameter. We offer the same size in a Load Range E as…
view full answer...Most likely the outside edge of your trailer tire is wearing because of an issue you are having with the suspension of the trailer. Check the suspension for worn out components or holes that are egg-shaped instead of round where the suspension…
view full answer...Related Searches
Filter Your Search
Contact and Help