Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Doug, You can definitely swap out the 5' bunks on the CE Smith Multi Sport Plus Boat and Kayak Trailer w/ Bunks #CE48870 with the 7' long replacement bunks #CE27845 for more support. I would just flip the front mounting brackets to have…
view full answer...It's pretty easy to determine the correct replacement leaf springs for your trailers, and there's different ways for double-eye springs and slipper springs. You do have to account for the sag, so go with ones that measure shorter than what…
view full answer...Oddly enough I can't find a decent u-bolt that we carry that would work well for your application.
view full answer...To help you get the correct springs, unfortunately the VIN is not a help as I tried to get information online. If you know the number of axles and axle capacities, then some simple measurements will help me get you the correct replacement parts.…
view full answer...I have a solution for you but the part #CE10190GA-4 is not available in a half kit so what you would want is the part #CE10190GA with the swivel bracket part #CE10206G. We don't have the bolt and nut though so you would need to supply that…
view full answer...The CE Smith Bolster and Swivel Bracket, #CE10100G and #CE10201G, do not use bolts with partial thread to allow the swivel bracket to move. Once you have the swivel bracket at the angle you need, you simply tighten the bolt down to hold the swivel…
view full answer...It can be a flat end as long as the flat part is long enough that it can reach past the wet bolt just fine. For your application it looks like the 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles #e69SR is the closest that we have as…
view full answer...The most I was able to find about the Coleman 4735CC201 leaf spring is that it's rated for 1,000 lbs which means it goes to a 2,000 lb axle. For that application we have the 4-Leaf Slipper Spring w/ Radius End #e69SR which measures 25-4/8"…
view full answer...To install the CE Smith Single Axle Trailer Fenders w/ Top and Side Steps #CE19503-2 you need 4 of the CE Smith Galvanized Steel Step #CE26212G. The mounting hardware isn't included because every trailer design is different so you can either use…
view full answer...We have hubs that are designed to fit spindle diameters that you mentioned of 1 inch and 1-1/6 inch. If you have a straight spindle with a 1 inch diameter you'd have a BT8 spindle and the hub part #8-258BTUC1 that you referenced would fit. If you…
view full answer...It could just be the angle but looking at the picture you attached it appears that you have a 1-3/4 inch diameter axle. This would be consistent too with the smaller 2,000 pound axles that are typically on jet ski trailers like what you have. I do…
view full answer...Your trailer appears to have steel fenders and we do offer these as well as tough ABS plastic types and aluminum fenders too. You can see all replacement trailer fenders on the linked page. Just click on your trailer's wheel diameter and your…
view full answer...Related Searches
Filter Your Search