Left Turn Signal Causes all Trailer Lights to Flash and Right Turn Signal Does Nothing
Question:
I need to rewire a boat trailer to fit a 4 pin attachment. I have a 97 Nissan pickup and have already purchased and installed the pigtail. All lights blink when I hit the left turn signal, no lights blink when I hit the right turn signal. Is there a diagram out there somewhere that can help me? Note: My trailer has six lights: 1 above each wheel, 1 at each back corner low and 1 on each side set on poles to guide the boat into the trailer if the trailer is underwater. What lights are brake lights, turn signals, tail lights, etc.
asked by: Gabe
Expert Reply:
If you have the Hopkins Wiring Harness # HM43505 installed on your 1997 Nissan pickup you will want to check the 4-flat connector with a circuit tester # PTW2993 and make sure that the wiring on the vehicle is correct and that you have a good ground.
It sounds like a ground problem on the trailer is what is causing your lighting problem. You will want to check that the white ground wire on the trailers 4-way is properly grounded to a good, clean area of bare metal on the frame.
You will also want to make sure that the trailer lights are grounded. If the trailer lights have a white ground wire coming out of the light, you will want to make sure that you have that wire grounded to a good clean metal area on your trailer. If the taillights do not have a white ground wire you will need to make sure the light is getting a good ground with the mounting studs. Some trailer lights are grounded by the studs that attach the lights to the trailer.
On the trailer you can use a circuit tester to test the wires going to the lights to determine which function is for that light.
Products Referenced in This Question
Product Page this Question was Asked From
Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: All Trailer Lights Blink When One Turn Signal Is Activated
- Shop: Tandem Axle Teardrop Trailer Fenders - Rounded Edges - Steel - 15" to 16" Wheels - Qty 2
- Shop: Trailer Wiring
- Shop: Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Hopkins Tail Light Converter with 4-Way Flat Trailer Connector
- Shop: Brake Controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Review of Hopkins Custom Fit Vehicle Wiring - Plug In Vehicle Wiring Harness 4 Pole Flat - HM43505
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Wiring Harness for a 1996 Nissan Pickup Truck
- Q&A: Converter Recommendation to Take Separate Turn Signals and Convert them to Combined
- Q&A: Will Hopkins Trailer Wiring Harness for 1995 Nissan Pickup Work with LED and Non-LED Taillights
- Q&A: Troubleshooting Trailer Wiring Where Both Lights Flash with Right Stop/Turn Circuit
- Q&A: Recommended Parts Needed To Install 7-Way Trailer Harness On 1993 Nissan Pickup
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Search Results: 44649
- Shop: Trailer Hitch
- Video: Choosing the Right Trailer Wiring
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Search Results: 25580
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Search Results: 68149
- Search Results: dust cap
- Video: Review of etrailer Trailer Fenders - Tandem Axle - HP64VR
- Article: Brake Controller Installation: Starting from Scratch
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Article: Towing a Trailer? Let's Talk About Brake Controllers