Review of etrailer Trailer Fenders - Tandem Axle Trailer Fenders - HP94VR Video

The Tandem Axle Teardrop Trailer Fender #HP94VR you were looking at is 9" wide the whole length of the fender, and at it's largest is 15" deep/tall.

The Backing Plate #HP72FR can be used with the Tandem Axle Teardrop Trailer Fenders #HP94VR. These backing plates are 69" by 12" and manufactured from 18 gauge steel. It can be cut if you are wanting to match the profile of the fenders.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Thanks for the photo. Honestly 5 inches of clearance from the fender to the top of the tire is fine if that is what you desire. We normally recommend 4 inches to allow for the suspension travel whether with leaf springs or torsion axles to allow…

The way to install the new #YR343R-6P roller is pretty simple. You'd can use pliers or channel locks to remove the existing retainer ring and the old washer. Then remove the old roller. install the new roller part #YR343R-6P and washer part…

Typically, brackets like #CE26098G-2 would be used for a stronger installation but it's certainly not unheard of to mount the #CE17900G fenders by bolting the side directly to the trailer.

The best ramps spring option we have would be the part #362SA7 which is 77 inches wide and has a lifting power of 150 lbs. It can be cut down to your specific custom needs and is designed to accommodate doors as small as 43 inches in width. Warning:…

CE Smith Single Axle Trailer Fender #CE17800G does not have pre-drilled holes, so you will have to drill them. You can reuse your original mounting hardware and brackets or you can use the bolt on brackets, #CE26098G-2. These mounting brackets have…

Erickson E-Track Cargo Control items like #EM59150, #E19148 and #E19146 are not painted but rather they are given a zinc coating treatment to provide corrosion resistance since they are made of steel. These are perfectly suitable for use on the deck…

I did not find anything on a HP54VK trailer fender, If you meant the #HP54VR Tandem Axle Teardrop Trailer Fenders, we do not have a custom fit fender backing plate that fits the #HP54VR. However, we do have the Backing Plate for Tandem Axle Trailer…

The Brophy D-Ring Tie Down Anchor w Backing Plate - Bolt-On - 1/2" Wide - Recessed - 1,600 lbs #RR5K are rated for 5,000 lbs break strength and will work just fine with your application. The 3/4 inch plywood floor is very strong and with the…

The Brophy Recessed Trailer D-Ring Tie Down with Backing Plate #RR5K is not application-specific so its preferred method of installation will vary from trailer to trailer. The main factor is the thickness of the material to which it will be mounted.…